Advertisement

Quick Links

Automatic Battery Charger
OWNERS MANUAL
PLEASE SAVE THIS OWNERS MANUAL AND READ BEFORE EACH USE.
This manual will explain how to use the charger safely and effectively. Please read and follow these instructions and precautions carefully.
1.

MARKINGS AND SYMBOLS

Read manual
before using product.
Do not expose
Never smoke or allow
to rain or snow.
2.

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions.
2.1
Children should be supervised to ensure that they do not play with the appliance. This appliance is not intended for use by persons (including children) with reduced physical,
2.2
sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Do not expose the charger to rain or snow.
2.3
2.4
Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock or injury to persons.
To reduce the risk of damage to electric plug and cord, pull by the plug rather than the cord when disconnecting charger.
2.5
An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If an extension cord
2.6
must be used, make sure:
• The pins on plug of extension cord are the same number, size and shape as those of plug on charger.
• The extension cord is properly wired and in good electrical condition.
• The wire size is large enough for AC ampere rating of charger as specified in Section 8.
Do not operate the charger with a damaged cord or plug. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
2.7
persons in order to avoid a hazard.
Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman.
2.8
2.9
Do not disassemble charger; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
2.10
To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Turning off controls will not reduce this risk.
WARNING: RISK OF EXPLOSIVE GASES.
2.11
a.
WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION.
FOR THIS REASON, IT IS OF UTMOST IMPORTANCE THAT YOU FOLLOW THE INSTRUCTIONS EACH TIME YOU USE THE CHARGER.
To reduce risk of battery explosion, follow these instructions and those published by battery manufacturer and manufacturer of any equipment you intend to use in
b.
vicinity of battery. Review cautionary markings on these products and on engine.
Do not use with non-rechargeable batteries. Use only with lead-acid type rechargeable batteries.
2.12
3.

PERSONAL SAFETY PRECAUTIONS

Consider having someone close enough by to come to your aid when you work near a lead-acid battery.
3.1
Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.
3.2
3.3
Wear complete eye protection and clothing protection. Avoid touching eyes while working near battery.
If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters eye, immediately flood eye with running cold water for at least 10 minutes and
3.4
get medical attention immediately.
NEVER smoke or allow a spark or flame in vicinity of battery or engine.
3.5
3.6
Be extra cautious, to reduce risk of dropping a metal tool onto battery. It might spark or short-circuit battery or other electrical part that may cause explosion.
Remove personal metal items such as rings, bracelets, necklaces, and watches when working with a lead-acid battery. A lead-acid battery can produce a short-circuit current
3.7
high enough to weld a ring or the like to metal, causing a severe burn.
Use charger for charging LEAD-ACID (STD, AGM or GEL) batteries with 6 cells (12V) and rated capacities of 12-45Ah (RP1202) or 20-230Ah (RP1210). It is not intended
3.8
to supply power to a low voltage electrical system other than in a starter-motor application. Do not use battery charger for charging dry-cell batteries that are commonly
used with home appliances. These batteries may burst and cause injury to persons and damage to property.
NEVER charge a frozen battery.
3.9
Protect your eyes.
Wear protective clothing.
Keep out of
flames and sparks.
reach of children.
Risk of explosive gases.
Disconnect the mains cable before
connecting or disconnecting
the clamps.
Risk of electric shock.
Use in a well-
ventilated area.
0099002149-01

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RP1210 and is the answer not in the manual?

Questions and answers

Summary of Contents for Schumacher RP1210

  • Page 1 Use charger for charging LEAD-ACID (STD, AGM or GEL) batteries with 6 cells (12V) and rated capacities of 12-45Ah (RP1202) or 20-230Ah (RP1210). It is not intended to supply power to a low voltage electrical system other than in a starter-motor application.
  • Page 2 PREPARING TO CHARGE If necessary to remove battery from vehicle to charge, always remove grounded terminal from battery first. Make sure all accessories in the vehicle are off, so as not to cause an arc. Be sure area around battery is well ventilated while battery is being charged. Clean battery terminals.
  • Page 3 10. ASSEMBLY INSTRUCTIONS 10.1 Remove all cord wraps and uncoil the cables prior to using the battery charger. 11. CONTROL PANEL START/STOP BUTTON Press to immediately begin charging your properly connected battery. If the button is not pressed, charging should begin in ten minutes. LED INDICATORS POWER (green) LED lit: The charger is connected to an AC outlet.
  • Page 4 MAINTAINING A BATTERY The RP1202 and RP1210 maintain 12-volt batteries, keeping them at full charge. It can charge and maintain both small and large batteries. NOTE: The maintain mode technology allows you to safely charge and maintain a healthy battery for extended periods of time. However, problems with the battery, electrical problems in the vehicle, improper connections or other unanticipated conditions could cause excessive current draws.
  • Page 5 WARRANTY TERMS AND CONDITIONS Schumacher Electric Corporation (the “Manufacturer”) or the resellers authorized by the Manufacturer (the “Reseller”) warrant this charger (the “Product”) for three (3) years, according to the following stipulations. Any and all warranties, other than the warranty included herein, are hereby expressly disclaimed and excluded to the fullest extent permissible under applicable law.
  • Page 6 • 6 •...
  • Page 7 • 7 •...

This manual is also suitable for:

Rp1202

Table of Contents