Leveling The Wings - CONCORD PRECISION SHANK DRILL Assembly Manual

3. Assembly
Procedure
1. Find a solid, level surface large enough for the machine when unfolded.
2.
Unfold the machine and fully raise the machine. Continue holding the hydraulic lever to let the oil
cycle through the lift system.
3. Hold the lift cylinder hydraulic lever in the raised position for one to five minutes to make sure all
cylinders are bled of air and fully extended.
4.
Stop the tractor engine, apply the park brake, and take the key with you.
5. Remove the transport locks.
6. Measure and record the height from the ground to the bottom of the wing frame tubes on the front
and rear of the wing.
7. Compare the measurements of wing to the main frame.
If the measurement for the wing is:
• more than the main frame measurement, lower the wing
• less than the main frame measurement, raise the wing.
figure 1
8. Adjust the adjusting screw (1) to raise or
lower the wing.
a) To raise the wing, loosen the jam nut (2)
and tighten jam nut (3)
b) To lower the wing, loosen the jam nut
and tighten jam nut (2)
Follow the same procedure for the wing on
.
the other side.
.
103
LEVELING WINGS
Fig. 1 FRONT