Advertisement
NOTE: (
For Backrest/Headrest option only) Make sure that the legs on the
backrest/headrest side flush with the top of the apron and the clip sits flat
on the bottom side of the apron as shown in Figure 5.
4. Tighten Hex Bolt with wrench until you can see lock washer flattening
out.
NOTE:
Make sure that the long stretcher cutout is facing inwards as shown
in Figure 3 and 4.
5. After attaching all four legs to the tabletop, attach the Long Stretcher 'C'
to the short stretchers (unfinished edge away from table top) with
socket hex 'K' on each end as shown in Figure 4.
6. (Table with Backrest/Headrest option) Secure clips to the bottm of the
Apron with philip screws 'N' as shown in Figure 5.
7. (Step 7 and 8 for Model# 4024 only) Attach Shelf 'F' to the long
stretcher by Hook and Loop velcro strips that are factory attached to
the bottom of the shelf as shown in Figure 6.
8. Remove the loop part of the velcro and adhere it in the center of the
short stretcher and carefully place the shelf into position as shown in
Figure 6 and repeat the same procedure for the other side.
NOTE:
Handle the shelf very carefully as dropping it on the corners could
result in damaging the corners.
Hook &
Loop
Velcro
Figure 6: Shelf with Hook & Loop Velcro
Rev. 101813 aj
Loop velcro
Page 2 of 2
Long Stretcher
Apron
bottom
Figure 4: Leg & Short Stretcher
Apron top
Figure 3: Leg & Short Stretcher
Long Stretcher cutout
Tabletop
Figure 4: Leg & Short Stretcher
Apron bottom
Clip
Figure 5: Clip secured to apron
©2013 HAUSMANN INDUSTRIES, INC.
cutout
Corner Plate 'H'
Long Stretcher 'C'
K
N
Advertisement
