Operating Instruction; Timing Function - SPT SH-1516D Owner's Manual

OPERATING INSTRUCTION

Check before turning on the machine
1. Check if the power wire is under good condition.
2. The product adopts 120V AC power supply, before use, please confirm if
the rated current of the power socket meets the local requirements with safe
grounding device, otherwise, please replace it with the qualified socket.
Vertical and horizontal
This unit can be used BOTH standing up or laying flat on its side depending on
the user's liking.
Start the machine
Plug the unit into a grounded 120V outlet, press the ON/OFF key (or press the
ON/OFF key of the remote controller) for start, the machine supplies air at high
power after start,the display will show the temperature of 95°F.
Mode setting
Press the "Mode button" to change settings in the following order: High Heat -
Low Heat - Fan - Auto mode - High Heat.
Temperature setting
Press the "+" or "-" to set the desired temperature with a range of 40-95°F. When
the desired room temperature is reached, the display will flash for 10s and the unit
will automatically go into standby mode. The unit will reactivate when room
temperature again drops below the desired temperature.

Timing function

Timing stop
When the electric heater is turned on, press the TIMER key to enter the timing stop
state (within 0-24 hours), then press the "+" key to increase the timing stop time by
1 hour once, and press the "-" key to decrease the timing stop time by 1 hour once.
Timing start
When the electric heater is in the standby mode, press the TIMER key to enter the
reservation start mode (within 0-24 hours), then press the "+" key to increase the
reservation start time by 1 hour once, and press the "-" key to decrease the
reservation start time by 1 hour once.
Swing function
the electric heater is in operation mode, press the "swing" key to open the swing
function, pressing this button to turn off the swing function; when the electric heater
stops heating function, the wind swinging function also stop.
4