Tilting The Table - Black & Decker BDSA100 Instruction Manual

ADJUSTING THE BACKSTOP SQUARE WITH THE SANDING BELT
WARNING: DISCONNECT MACHINE FROM POWER SOURCE.
1. Before adjusting, move the belt tension lever (A) Fig. 23 all the way to the left to the "TIGHTEN" position.
2. Place a square (B) Fig. 24 on the sanding belt with one end of the square against the backstop. See if the
backstop is square with the sanding belt.
3. Loosen the screw (C) Fig. 24 and adjust the backstop.
A

TILTING THE TABLE

WARNING: DISCONNECT MACHINE FROM POWER SOURCE.
You can tilt the table up to 45 degrees to the right by
loosening the table lock knob (A) Fig. 25.
WARNING: After tilting, the table must be
repositioned on the support rod (B) Fig. 25 to
provide a maximum of 1/16 in. distance between
the sanding disc (C) and the edge (D) of the table to
avoid trapping the work or fingers between the disc
and the table. To reposition the table assembly,
loosen the screw (E), move the table assembly on
the rod (B) and tighten the screw.
ADJUSTING THE TABLE SQUARE WITH THE SANDING DISC
WARNING: DISCONNECT MACHINE FROM POWER SOURCE.
1. Use a combination square with one end on the table
and the other end against the sanding disc (Fig. 26).
See if the table is 90 degrees to the disc.
2. To adjust, loosen the table lock knob (A) Fig. 26,
move the table square with the disc and tighten the
lock knob (A).
3. Adjust the pointer (B) Fig. 26 to the "0" degree mark
on the angle scale.
Fig. 23
13
B
C
Fig. 24
C
E
A
Fig. 25
B
Fig. 26
D
B
A