LAON TECHNOLOGY LT750 Series Quick Reference Manual

LT750
WIRELESS INTERCOM EXPERT SYSTEM QUICK REFERENCE
28 JULY 2017 Rev. 1.1
1 5
3 17
2
4 6
Front panel of the Base Station, LTWI-BS750
1. Headset TALK button with indicator light
2. Headset communication group button
3. 4-Wire button with indicator light
4. 4-Wire communication group button
5. AUX IN, AUX IN/OUT button with indicator light
6. AUX IN, AUX IN/OUT communication group button
7. RF ALERT indicator light
8. Remote Base Station LINK Indicator light
9. Remote Base Station ACTIVE indicator light
10. Headset speaker volume control (UP)/Menu selection button
11. Headset speaker volume control (DOWN)/Menu selection button
12. Menu selection button (LEFT)
13. Menu selection button (RIGHT)
14. Menu SET button
15. Headset cable connector
16. Hands Free/PTT mode selection button
17. OLED Display
2
1
3
5
6
4
7
8
Front and rear panel of the Belt Pack, LTWI-BP750
BASE STATION DISPLAY MENU
<MAIN Menu>
Use UP/DOWN/LEFT/RIGHT
button to move
<VOLUME Menu>
<UNLATCH Menu>
<BELTPACK>
<MULTI-BS Menu>
<MONITOR Menu>
<SET GROUP >
<RBS
Menu>
<BS
Menu>
HF/PTT key
▣ Pressing SET for 2 seconds on any menus will lead you to the NORMAL menu.
to move
7
8 10 14 15
9 16 12 11 13
9
10
11
<NORMAL Menu>
Press SET to move from
NORMAL to MAIN menu
<RESET Menu>
<LABEL/GROUP/PAIR Menu>
<FREQ-MONITOR>
<SELECT RF CH>
<TX ON/OFF(Hidden menu)>
LTWI-BS750 BASE STATION CONTROLS AND CONNECTIONS
1 2 3
Rear panel of the Base Station, LTWI-BS750
1. Antenna connector
2. AUX IN connector
3. AUX OUT connector
4. 4-Wire and Multiple Base Station connector
5. Power switch
6. Antenna connector
7. 8-OHM speaker 2-pin spring clamp connector
8. USB connector
9. LAN RJ-45 connector
10. Power connector
11. Wall-mount bracket holder (Bottom)
LTWI-BP750 BELT PACK CONTROLS AND CONNECTIONS
1. Headset cable connector
2. OLED display
3. TALK button with indicator light, TALK button for the former
group selected in TWO GROUPS mode
4. Power (PWR) button
5. Headset communication group (GRP) button, TALK button for
the latter group selected in TWO GROUPS mode
6. Headset speaker volume control (UP) /
Menu selection button
7. Menu SET button
8. Headset speaker volume control (DOWN) /
Menu selection button
9. Belt clipper
10. Battery cover
11. Charger terminals (Bottom)
BELT PACK DISPLAY MENU
MS
▣ Pressing PWR button slightly on any menus will lead you to the NORMAL menu.
VOICE MESSAGES
"Beep", "Maximum", "Minimum", "Group
Base Station:
"Group two", "Group three", "Group four", "Group five", "Group all"
"Power on", "Power off", "Hands free on", "Hands free
Belt Pack:
off", "Beep", "Maximum","Minimum", "Audio channel is busy"
"Unlatched", "Change battery", "Out of coverage",
"Group two", "Group three", "Group four", "Group five"
5
4
10
7 8 9 11
Press SET to move from
<NORMAL Menu>
NORMAL to MAIN menu
<MAIN Menu>
Use UP/DOWN button to move
<HANDS FREE on/off>
<SPAKER volume>
<MICROPHONE gain>
<SIDETONE volume>
<TWO GROUPS menu>
<MODE SELECTION menu>
<LOW CUT menu>
<HANDSOFF SENSITIVITY>
to move
"Group one"
6
one"
1