Operation - Earlex SS77USSG Operating Manual

EN
wood needs to be steamed. A general rule to follow is that you should steam the
wood for 1 hour per every inch thickness of the wood. So for ½" thick pieces
you should allow 30 minutes. You will need a mould or jig to hold the wood in
place until it dries out after you remove such from the Steam Box.
*This is a general outline on building a Steam Box.*
*There are many websites available to use for more detailed instructions.*

operation

•
R emove filler cap and fill unit with clean water to the MAX level line
indicator. Replace cap (Fig. 1+2).
•
S crew hose onto threaded outlets of boiler and hose adapter, hand-tight is
sufficient. Do not overtighten (Fig. 3).
•
C onnect supply cord from unit to power socket-outlet and switch on (Fig. 1, 4).
important: When connecting the cordset to the unit, make sure the flap
i
is fully open and does not prevent the plug being fully inserted. Refer to
diagram below.
If the flap touches the ribs on the cordset it may prevent the cordset
inserting fully into the unit.
Flap
•
l t can take up to 15 mins (approx.) before steam is produced - depending on
fill water quantity and temperature.
•
D o not leave unattended and keep children and pets out of the room.
•
J ust before full steam production a small amount of bubbling and water will
occur at the hose adapter.
•
B eware of hot water discharge prior to steam emission.
•
O perate steamer until water level is low, then unplug unit and allow to cool
for at least 2 minutes (Fig. 1, 7).
Warning: Hot liquid or steam can burn. Danger of scalding. Steam
may also condense into boiling droplets. Steam should not
be directed towards electrical appliances. Danger of scalding
appears on the cap as either symbol.
Beware of steam - before removing the filler cap and refilling unit.
When finished, allow to cool completely and empty unit. Always
store unit empty.
6
Flap
Cordset
SS77USSG
Flap
Cordset