Advertisement
5. This appliance is not intended for use by persons with reduced physical,
sensory or mental capabilities. The appliance must not be operated by
children or persons who have not been instructed accordingly. Children
should be supervised to prevent them from playing with the appliance.
6. The operator must use the appliance correctly. When working with the
appliance, he must consider the local conditions and pay due care and
attention to other persons, in particular children who are nearby.
Caution
1. Do not use the machine if the persons nearby do not wear safety
protection device.
2. Wearing protective clothing and safety goggles to protect against
splash back containing water or dirt.
3. Create stability for the appliance prior to all work on or with the appliance
to prevent accidents or damage. The stability of the appliance is
warranted when it is placed on to an even surface.
4. For safety reasons, we recommend that you operate the appliance only
via an earth-leakage circuit breaker (max. 30mA).
5. Make sure that the power cord or extension cables are not damaged by
running over, pinching, dragging or similar. Protect the power cable from
heat, oil, and sharp edges.
6. Never leave the appliance unattended when it is in operation.
>> OPERATION
Special accessories expand the possibilities of using your appliance.
Please contact the dealer for further information.
Illustrate accessories before start-up.
1. Install coupling for water connection (pic A).
Screw the coupling to the water connection on the appliance.
2. Install high pressure hose (pic B. pic K).
Insert the high pressure hose tightly in to coupling on the appliance, it will
lock in audibly. Note:make sure the connection nipple is aligned correctly.
Check the secure connection by pulling on the high pressure hose.
3. Install the storage of trigger gun (pic C).
Insert the storage of trigger gun and push down all the way.
4. Install spray lance (pic F).
Push the spray lance into the trigger gun and fasten it by turning it
through 90 degree.
www.PyleUSA.com
4
Water Supply
Impurities in the water can damage the high pressure pump and accessories.
All high pressure washer (except hot water system) use cold water.
The suitable water temperature is 41°F to 140 °F.
Water Supply from Mains
Observe regulations of water supply.
For connection values, use bre-reinforced water hose (not included) with a
standard coupling, normally the length is 5m, connect the water hose to
the appliance and water supply.
1. Open the water tap
2. Unlock the lever on the trigger gun
3. Pull on the lever of the trigger gun
4. Turn ON the appliance (pic G ON: open OFF: close)
Start Up
Dry runs lasting longer than two minutes lead to damages to the high
pressure pump. If the appliance does not build up pressure within two
minutes, switch it o and proceed as instructed in the Chapter "Trouble-
shooting". The trigger gun is subjected to recoil force when the water
washer is discharged. Make sure that you have a rm footing and are also
holding the trigger gun and spray lance rmly. The spray lance has two main
settings stream and fan for easy cleaning (pic H).
Caution
Prior to cleaning, make sure that the high pressure washer is placed safely
on level ground. Wear protective goggles and protective clothing during
the cleaning process.
Notes: Release the lever ofthe trigger gun, the device will switch o again.
High pressure washer remains in the system.
5
www.PyleUSA.com
Advertisement
