Table of Contents
Advertisement
Main functions
______________________________________________________________________
Self-test
Switch ON the machine by pressing the power switch on the back. In the main display you can see „0.00" after
self checking.
Counting modes
Free counting mode (value and number counting)
The M 3 will start counting after pressing the START/STOPP button. After counting all coins (no more coins
on the hopper), the device will stop counting automatically and you can see the result on the display. If you
want to stop the counting procedure while counting, please press the START/STOPP button. By pressing the
„Sorten" - key after the counting procedure, you can see the counted number of each single denomination.
By pressing the „Sorten" - key again, you can see the next denomination (0,01; 0,02; 0,05 ...). Press the „C"
- key for showing the total amount again. By pressing the „C" - key again, you will clear the counting result.
Batch mode
Please set the batch numbers as follows:
By pressing the
the denomination for setting the batch number. (2,00; 1,00; 0,50; ...). If you can see the wished
denomination on the display (for setting), you can setup the number by pressing the „Bündel" - key. The batch
number will be increased (+5 or +10) and deactivated by pressing the „Bündel" - key. For setting the batch
number (+1 / -1), please use the „+" or „-" keys. For saving the setted batch numbers, press
/ STOPP". The device will stop counting by reaching a number of one denomination presetted like that. The
denomination of the reached number will be shown in the display. Now you can take away the counted coins
of the denomination shown in the display. For continue counting, please press the START/STOPP - key. For
deactivating the batch function, please set the batch number „0". After restart of the machine (switch power
off and on again), the preset batch numbers are activated automatically.
Trouble shooting
______________________________________________________________________
Universal
By switching ON the device, it will test its own functions.
If there is any error message in the display, please refer to the technical support of hbw cash solutions.
Put the device on a level and planer surface, so that it´s placed firm and safe. Otherwise problems refering the
counting / sorting result can appear. It can possibly happen, that a coin will block the machine.
A blocked coin can be removed with the finger from below, therefore disconnect the power plug first.
Maintenance
As the machine is exposed to wear, it is advisable to clean the device professionally. hbw cash solutions
offers services for that. Feel free to contact the technical support of hbw cash solutions.
As the operating mode of the machine is based upon sensor technology,
do not expose it to direct solar radiation.
hbw cash solutions can take no liability for counting and sorting coins.
Take care, that only permitted coins are counted, otherwise damages to the device can appear.
Before cleaning the machine the power supply has to be disconnected unconditionally!
Clean the device exclusively with a dry brush, the compressed air* cleaner B8
or the special cleaner R 605 of hbw cash solutions.
(* alternative: Compressor with dry / oil free air. Max. 4 bar)
Please never clean the device with chemical cleaner.
8
- key, you can activate the batch function. By pressing the
key again, you can choose
or „START
Advertisement
Table of Contents
