Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Haug AG 35
Summary of Contents for Haug AG 35
- Page 1 Operating instructions AG 35...
- Page 3 3. Design, operating elements 8. Technical data 4. Installation 5. Application Notes on operating instructions In these operating instructions, the AG 35 is also referred to as "the unit". Pictorial markings used In these operating instructions Caution! Important instructions! Danger!
-
Page 4: Intended Use
Operating instructions AG 35 Safety The charging generator AG 35 is operationally safe, provided that it is operated in accordance with its intended use. In case of misuse, dangers may result: - for life and limb of the operator, - for the unit and other assets. - Page 5 Operating instructions AG 35 Installer qualifications The unit may be installed by trained electricians only. The above mentioned person must have read the operating instructions and must follow the instructions, notes and safety advice. Operator qualifications The unit may be maintained and put into operation by trained electricians only or by authorized persons instructed in the potential dangers.
- Page 6 Operating instructions AG 35 Figure 2 Operating elements charging Fuse (for replacement see „Maintenance and repairs“) AC 250 VM AC 250 VM X, XA X, XA On/Off switch; green lamp lights up when unit is switched on. Operating elements discharging...
- Page 7 Operating instructions AG 35 Installation The unit may be installed and put into operation by trained electricians only. The above mentioned person must have read the operating instructions and must follow the instructions, notes and safety advice. Important installation instructions The charging electrodes connected to the charging generator carry high voltage during operation.
- Page 8 Operating instructions AG 35 Application Preconditions: The charging generator and the charging electrode must be connected correctly. Protective equipment against direct contact with the charging electrode must be provided. The unit may be put into operation by trained electricians only or by authorized persons instructed in the potential dangers.
- Page 9 Danger of fatal accidents! Do not open unit! This unit does not include any parts which can be maintained or repaired by the operator. HAUG only is authorized to repair or calibrate the unit. Should the unit prove defective or if a defect is suspected, switch off unit immediately and secure against subsequent reuse.
-
Page 10: Technical Data
Operating instructions AG 35 Technical data Characteristics and specification Reference temperature 23 °C Charging High voltage terminals 2 HAUG high voltage terminals (standard) High voltage U = approx. 40 kVDC (no load), positive or negative Short-circuit current I k ≤ 0,8 mA... - Page 11 Operating instructions AG 35 Ambient conditions Ambient temperature: Rated application range +5 °C to +45 °C Extreme range for storage and transport -15 °C to +60 °C Humidity: Rated application range 20 % to 65 % RH Extreme range for storage and transport...
- Page 12 HAUG GmbH & Co.KG Friedrich-List-Straße 18 D-70771 Leinfelden-Echterdingen Telefon 07 11 / 94 98 - 0 Telefax 07 11 / 94 98 - 298 www.haug.de E-Mail: info@haug.de HAUG Biel AG Postfach CH-2500 Biel/ Bienne 6 Johann-Renfer-Strasse 60 CH-2500 Biel/ Bienne 6...
Need help?
Do you have a question about the AG 35 and is the answer not in the manual?
Questions and answers