Hobie H-Crate Assembly And Installation Instructions

Hobie H-Crate Assembly and Installation Instructions
2 Slide the wall sections into the corners using the
tabs at the top and bottom to align.

Parts List

1 4 x Corner 1
2
2 x Short Wall
4 x Strap
3
4
2 x Long Wall
2 x Long H-Rail
5
2 x Short H-Rail
6
7 1 x Bottom
8 x Self Drilling
8
Screws
8 x Thread
9
Forming Screws
Tools needed:
Phillips Screwdriver
(optional) Drill and
Driver Bit
3
With the flat surfaces aligned, insert 2 long and 1
short H-Rail section into two upside down corner
pieces. Then connect the remaining corners using
the short H-Rail segment sliding both assemblies
together. Ensure the rails go all the way into the
corners. You may need to push them together using
a flat surface for leverage.
Align the bottom of the crate. To secure it, first push
in the centers of the walls to clear the center snaps
and install the thread forming screws in the corners.
(optional) To add extra ridgitiy, you may install the self
tapping screws into the holes on top of the corners
using a drill.
thread
forming
self
tapping
REV 141203