Windshield Wipers; Windshield Washers - Hyundai Creta 2019 Owner's Manual

Hide thumbs Also See for Creta 2019:
Table of Contents

Advertisement

Windshield wipers

Operates as follows when the igni-
tion switch is in the ON position.
MIST : For a single wiping cycle,
move the lever to
position and release. The
wipers will operate continu-
ously if the lever is held in this
position.
OFF : Wiper is not in operation.
INT : Wiper operates intermittently at
the same wiping intervals. To
vary the speed setting, move
the speed control lever.
i
Information
If there is heavy accumulation of snow
or ice on the windshield, defrost the
windshield for about 10 minutes, or
until the snow and/or ice is removed
before using the windshield wipers to
ensure proper operation.
If you do not remove the snow and/or
ice before using the wiper and washer,
it may damage the Wiper and washer
system.

Windshield washers

(if equipped)
■ Type A
or MIST
■ Type B
In the OFF position, pull the lever
gently toward you to spray washer
fluid on the windshield and to run the
wipers 1-3 cycles. Use this function
when the windshield is dirty. The
spray and wiper operation will contin-
ue until you release the lever.
If the washer does not work, check
the washer fluid level. If the fluid level
is not sufficient, you will need to add
appropriate non-abrasive windshield
washer fluid to the washer reservoir.
The reservoir filler neck is located in
the front of the engine compartment
on the passenger side.
OGS045071L
When the outside temperature is
below freezing, ALWAYS warm
the
windshield
defroster to prevent the washer
fluid from freezing on the wind-
shield and obscuring your vision
which could result in an acci-
dent and serious injury or death.
OGS045072L
WARNING
using
the
3-89
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents