Related Manuals for Booth DRY125
Summary of Contents for Booth DRY125
- Page 1 Installation Instructions DRY125 Kitchen Cooler Part Number 3B3967 Issue OR [18/06/09} Booth Dispensers Ltd, Moor Park Avenue, Blackpool, Lancashire Tel +44 (0)1253 501800 www.booth-dispensers.co.uk...
- Page 2 Installation Instructions Introduction The Booth Kitchen Cooler is designed to be fitted into a kitchen cupboard, ideally below the sink, in close proximity to both mains water and electrical supplies. If an electrical socket is not close to the intended location of the cooler, one should be fitted by a qualified electrician. The cooler is intended to be installed in conjunction with a water filter and dispense tap which are available as an optional kit from Booth Dispensers.
- Page 3 3. Also ensure that there is adequate space at the back of the cabinet and a way for warm exhaust air to escape, a 50mm gap between the panel and wall should be sufficient. 4. Identify the best location for the cooler, tap and filter by reference to the illustration above, the water circuit diagram opposite, the tap and filter...
- Page 4 It is illegal to simply scrap a refrigeration unit. Before a unit can be scrapped it must first have the gas removed by a specialist using specialist equipment. Please contact Booth Dispensers ltd who will be happy to provide a quotation for disposal.
Need help?
Do you have a question about the DRY125 and is the answer not in the manual?
Questions and answers