Related Manuals for Warren Evans Chester Ottoman
Summary of Contents for Warren Evans Chester Ottoman
- Page 1 London ASSEMBLY GUIDE New Upholstered and Wooden Space Saving Ottoman Bed Range Chester Ottoman (Wooden) Oxford Ottoman (Wooden) Richmond Ottoman Ludlow Ottoman Stockport Ottoman Minster Ottoman Ripley Ottoman...
- Page 2 Please ensure that you wash your hands or that your gloves are very clean even after and during unwrapping the products, to not mark the finished product in any way. We wish you to have an excellent clean Warren Evans bed! When unwrapping these beds please keep all the wrapping intact should it be needed for returns.
- Page 3 The metal ottoman lifting mechanism must go at the head end of the bed. Make sure the exterior of the side (A) overlaps the head end (B). Make sure that the sides of the bed are Hook the bracket (C) over the bolts (D), one facing up side at a time, onto the headboard first.
- Page 4 Unwrap the lightest long package carefully. There are 3x cross beams (A), a slat with ply support (B) and a slat with a handle (C) which will be used later. Head End Foot End ottoman base Place the 3x cross beams (A) into the cut out slots which appear on the inside of the side panels, at the bottom.
-
Page 5: Aerial View
Now using just your fingers tighten all 12 bolts as much as possible all the way around all 4 legs. AERIAL VIEW Head End Head End Foot End Foot End Shown here is an aerial view looking down on your bedframe, please ‘square it up’ so that it is not ridiculously out of kilt. - Page 6 If your bed is a super king size or a small super king size (6ft or 5ft 6inch wide) you will need to insert the centre beam. Take the 2 slats (head end (B) and foot end (C)) that are available and place them onto the bed as shown.
- Page 7 Please space the foot end slat appropriately and screw down all 4 screws, and now do the same with the head end slat. Please continue the same process with all of the other slats, which are in the last package to be opened. Please spread these slats out so that they are equally spaced in between the first and last slat.
- Page 8 IMPORTANT: LAST STEP OF YOUR BED ASEEMBLY The 2 hoop-lock screws at the foot end of each side of the bed must be completely unscrewed and then screwed back in 4 turns to keep it conveniently located for use whenever your bed is to be moved. Failure to remove far enough before use could scratch the stationary side rail and damage it.