Warren Evans Chester Ottoman Assembly Manual page 8

12.
IMPORTANT:
LAST STEP OF YOUR BED ASEEMBLY
The 2 hoop-lock screws at the foot end of
each side of the bed must be completely
unscrewed and then screwed back in 4
turns to keep it conveniently located for use
whenever your bed is to be moved. Failure to
remove far enough before use could scratch
the stationary side rail and damage it.
AND THE FIRST STEP IF EVER MOVING /
DISASEMBLING YOUR BED.
Failure to use it when moving the bed
creates an injury risk as this screw keeps
the ottoman sides from flipping up
unexpectedly.
DISASSEMBLING YOUR BED
The hoop-lock screws shown must be
completely screwed in. So that the ottoman
can no longer be raised until a mattress is
about to be placed on it again for normal use.
To disassemble reverse the order of the
assembly instructions, but first number the
slats as shown (1, 2, 3, 4, 5 etc...) so that
they screw back into the same places when
reassembling.
Make sure hands, surfaces are clean and all
of the parts of the bed do not get damaged
against rough or hard surfaces. Thank you.
8