Parameter Menu - Vemer HT NiPt Series User Manual

that can be modified by pressing "up" (�). To display the value of the parameter,
press "OK" (press "OK" a second time to return to the display of the parameter
label).
- To modify the parameter value, hold down "OK" for at least 3 seconds.
- The parameter value will start to flash and it will be possible to increase or
decrease it with the "up" (�) and "down" (�) keys.
- To confirm the value set, press "OK".
The parameter will stop flashing and the new value will be displayed.
- It is possible to return to normal operation at any time by pressing "down" (�)
(or if no key is pressed for at least 40 seconds).
Note: if no key is pressed for at least 40 seconds, the instrument leaves
the parameter modification without memorising the changes made.
Note: During the display and modification of the parameters, the
instrument will continue to operate with the previously set parameters.
If "password 2" is enabled (access password for the protection of the settings-see
system menu), when the "up" (�) and "down" (�) keys are held down
for three seconds from normal status, the message "- - - " will appear.
To set the parameters, enter the previously set password (a number from 0 to 255)
with the "up" (�) and "down" (�) keys and press "OK" to confirm.
If the password is entered correctly, the label of the first menu will appear.
Otherwise, the system will return to normal status.
To simplify the programming of the instruments, the parameters are grouped into
various menus, in the following order:
— [REG] regulation menu
— [OUT] output menu
— [ING]
outside input menu
— [ALR] alarm menu
— [DSP] display menu
— [SNS] sensor menu
— [SYS] system menu
— [ADD] special parameter menu (for special operating mode only)

PARAMETER MENU

- 41 -
User Manual Digital Heat Regulators