Cambridge SoundWorks FourPointSurround FPS1800 Installation And Operating Instructions Manual page 8

All manuals and user guides at all-guides.com
FPS1800.fm Page 3 Tuesday, July 18, 2000 4:48 PM
Mount the rear satellites only on
walls that are structurally sound.
1 Drill a hole about 0.5 cm
(¼ inch) deep into wall.
2 Tap plastic anchor into hole
until it is flush with wall.
Screw a M5 x 25 mm screw
3
into anchor, leaving about
0.5 cm (¼ inch) protruding.
Slip keyhole slot of each
5
rear satellite onto protruding
screw.
3
Position the satellites behind you
1
and slightly above ear level.
4 Apply rubber
pads on the
back of each
rear satellite.
Note: Typically, the shorter
3-meter cables are used for
the front satellites.
Apply identification
label to back of
satellite.
Thread satellite
3
Attachment arm.
cable through
hole in desktop
stand.
Push back red tab on
2
satellite. Insert bare end of
red-banded cable into hole
and release tab to lock.
Repeat for unmarked cable;
insert into black tab.
4 Insert attachment
arm into socket at
back of satellite.
5 Apply identification
label to cable.