Programming The Remote Control - LG 42PC5D Series Owner's Manual

APPENDIX

PROGRAMMING THE REMOTE CONTROL

The remote control is a multi brand or universal remote. It can be programmed. to operate most remote
controlled devices from other manufacturers.
Note that the remote control may not control all models from other brands.
Programming a code into a remote mode
To find out whether your remote control can operate each device without programming, turn on the device
1
(such as a VCR) and press the corresponding mode button on the remote.
After that, press the
need not be programmed. If not, the remote should be programmed to operate the device. The program-
ming procedures are explained below.
Press the
2
device button is illuminated.
If you don't press any button for 20 seconds, the light on the mode button will be turned off. In that case,
you have to repeat from step 2.
Enter the appropriate code from the code table on the following pages. When pressing the button, the light
3
blinks at a time. If the device turned off, the programming is successful.
4
Press the
5 Test the remote control functions to see if the device responds properly. If not, steps 2-5.
84
P P O O W W E E R R button. If the device is turned off and it responds properly the remote control
M M E E N N U U and M M U U T T E E button continuously at the same time for two seconds; the currently selected
M M E E N N U U button to store the code. After blinking twice, this code is stored.