Table of Contents
Advertisement
Installation Procedure
Accessibility Requirements
Note: Only lavatory installations in a public space must
comply with the knee and toe clearance
dimensions,however we recommend these standards
be used for both private and commercial installations.
Also makesure that all state and local building codes
are followed when installing this unit.
19" (48.5 cm)
17" Minimum
25" Maximum
m The top of the vanity should not exceed 34" (86.4 cm) from
the floor.
m The "knee space" below the apron of the vanity top should
be a minimum of 27" (68.6 cm) from the floor.
m The front edge of the sink should be between 17" (43.2 cm)
and 25" (63.5 cm) from the wall.
m The faucet should be a maximum of 19" (48.5 cm) from the
front of the sink.
8" (20.3 cm)
ADA-LB-003a
m No part of the sink or the plumbing should be within the gray
area shown in the drawing.
Swan
MAX.
ADA-LB-002a
6" (15.2 cm)
9" (22.9 cm)
Maintenance and Cleaning
Care and Cleaning
The Swanstone products are stain and abrasion resistant;
however, the finish requires reasonable care.
Because cleaning products change over time, always check
IMPORTANT NOTICE
the manufacturer's instructions to make sure it is compatible
with plastic. DO NOT use a cleaner if the label indicates
it should not be used on plastics. DO NOT use spray-on
cleaners that require daily use without immediately rinsing with
water to stop the chemical cleaning reaction because damage
will result and void the warranty.
Day-To-Day Cleanup
Clean your Swanstone vanity top with powdered abrasive
cleaners. Use of a Scotch Brite pad is recommended to
remove stubborn stains. Occasional use of a mild bleach and
water solution ensures that the original luster is maintained.
Simply wipe the surfaces with a clean towel to remove
watermarks and residues. All Swanstone products can be
cleaned with warm water, a soft cloth, and normal household
detergents or cleansers, such as Fantastic, Formula 409,
Clorox Clean-up, Handy Andy, Mr. Clean, or Lestoil. Always
rinse off cleaners within five minutes of application.
Occasional scrubbing with household abrasive cleaners
ensures that the original luster is maintained.
For the most stubborn stains, fill the Swanstone vanity bowl
about one-quarter full with a 50/50 solution of bleach and
water. After ten or fifteen minutes of soaking, drain solution
from the bowl as you wash and rinse both sides and bottom.
Note: Do not use steel wool or metal scourging pads
Cleaners designed to remove iron or rust should not harm
Swanstone.
White automotive rubbing compound may be used to remove
stubborn marks or discoloration.
Surface Repair
Light Scratches
Use 400 grit sandpaper to remove light scratches in the
surface.
Deep Scratches or Gouges
For deeper scratches or gouges, use 220 or 320 grit
sandpaper. A "Scotchbright pad" can be used to blend the
repair into the surrounding area.
14
800-325-7008
Advertisement
Table of Contents
