5. Do use water of temperatures at 0°c to 40°c. Limited Warranty Splosh Wash Limited will warrant the product for a period of 12 months from the date of purchase. Please keep your warranty card or original sales invoice to validate the warranty period.
Warning - To reduce the risk of injury Do not leave the unit unattended when plugged in. Unplug from power port when not in use and before any maintenance of the unit. This is NOT a toy. Close attention is necessary when used near children. Use only the manufacturer’s recommended accessories and replacement parts.
How to Operate Take out the charger from the Fill tank with fresh water. Unbuckle the 4 plastic hinges, compartment and plug into IMPORTANT: Water take off the lid, connect the mains to activate the cleaner. Temperature at 0°C to 40°C. reservoir lid to the base &...
Spray Gun Assembly Connect the shower head to the spray nozzle. Pushing the shower head to the spray nozzle, firmly line up the salient points on the shower head with the holes on the spray nozzle. Spray gun operation: Intermittent flow For intermittent flow pull and release the trigger repeatedly.
Automatic shutoff When the trigger is released the dynamic pressure shuts off the motor automatically. When the trigger is pressed, the unit automatically activates and pressure is formed once again with a slight delay. To ensure correct automatic shutoff operation, the time interval between trigger release and engagement must not be less than 5-10 seconds.
General Maintenance Warning: always disconnect the plug from the power supply before any maintenance is started. Water Filter: Check the water filter on the motor base is free from debris. Clean the filter when necessary. Nozzle Clogged: A clogged nozzle will cause the operating pressure to be too high causing the Splosh #1 to surge.
The unit must be stored in a partial state-of-charge, ideally 50% (charging the battery § about 1 hour after each time of use), recommended temperature 0°C ~20°C, if it is not in regular use, be sure to charge the battery to approx. 50% SOC instead of fully charged at least every 3 months.
Trouble Shooting Splosh #1 Problems Correction The pump will not start v Check if the battery is out of power or not. v Check if the hose is well connected to the outlet connector or not. v Check if the unit has been locked or not. Every new unit will be locked when leaving the factory by a long press of the on-off switch for over 5 seconds, to activate it, simply recharge the battery with the provided charger for a few...
Page 12
Specification: • Pressure (PSI): 43.5 to 130.5 • Voltage: 12V (DC) • Power: 45W • Hose: 2.0 meter • Water flow: 2.0L/min • Capability: 5 Litres • N.W.: 2.2 KGS • G.W.: 2.5 KGS • Dimension: 31 X 31 X 18.5 CM •...
Need help?
Do you have a question about the Splosh 1 and is the answer not in the manual?
Questions and answers