YES
YES
CHANGE
CHANGE
STATUS
STATUS
DEVICENET?
DEVICENET?
(OFF)-OK?
(OFF)-OK?
NO
NO
(ON)
(ON)
ESD ACTION
ESD ACTION
(IGNORE)-OK?
(IGNORE)-OK?
NO
NO
(CLOSE)
(CLOSE)
(OPEN)
(OPEN)
(STOP)
(STOP)
(POSITION)
(POSITION)
3
4.6.2 View Settings
Refer to Bulletin LMAIM1306/2306, MX Installation and Operation Manual to access the "VIEW
SETTINGS" menu. Verify the settings as follows:
5
View DeviceNet Status
Figure 5.1 – DeviceNet Screens
YES
YES
YES
YES
BAUD RATE
BAUD RATE
DNET ADDRESS
DNET ADDRESS
AUTO-OK?
AUTO-OK?
NET CTRL-OK?
NET CTRL-OK?
NO
NO
NO
NO
(125K)
(125K)
(0-63)
(0-63)
(250K)
(250K)
(500K)
(500K)
(NET CTRL)
(NET CTRL)
YES
YES
COMM LOSS ACTION
COMM LOSS ACTION
*
*
YES
YES
MOVE TO
MOVE TO
XXX% OPEN
XXX% OPEN
(POSITION)
(POSITION)
NO
NO
(0-100%)
(0-100%)
VIEW DNET STATUS?
This selection permits the User to view pertinent information which summarizes the status of the
DeviceNet option board.
VIEW MODULE STATUS?
•
Answer "YES" to determine status of individual DN board within the actuator.
•
Configuration choices are:
•
"OFF" = board installed but turned off
•
"OPERATIONAL" – The device is operating in a normal condition.
•
"STANDBY" = The device needs commissioning due to configuration missing, incomplete or incorrect.
•
"RECOVERABLE FAULT" = Conditions that can cause this event are e.g. communication fault, power
fault or Limigard fault of the SMT Main Board. Device may need resetting.
•
"UNRECOVERABLE FAULT" = Internal Diagnostic Fault detected e.g.
•
Receive Queue Overrun
•
Transmit Queue Overrun
•
CAN Controller Overrun
•
Device may need replacing.
•
"SELF TESTING" = The device is in self-test mode.
VIEW NETWORK STATUS?
Answer "YES" to determine status of DN network.
•
"NOT ON LINE" = Device is not on-line.
Limitorque MX DeviceNet Field Unit FCD LMENIM2328-00 – 11/05
YES
YES
YES
YES
ANALOG SCALE
ANALOG SCALE
CHANGE PROP
CHANGE PROP
(0-100)-OK
(0-100)-OK
DEAD BAND?
DEAD BAND?
NO
NO
NO
NO
(0-255)
(0-255)
(0-4095)
(0-4095)
YES
YES
(NONE)-OK?
(NONE)-OK?
*
*
NO
NO
(CLOSE)
(CLOSE)
(OPEN)
(OPEN)
MOVE TO
MOVE TO
(STOP)
(STOP)
XXX% OPEN
XXX% OPEN
NO
NO
(0-100%)
(0-100%)
YES
YES
YES
YES
PROP BAND
PROP BAND
DEADBAND
DEADBAND
(8%)-OK?
(8%)-OK?
NO
NO
NO
NO
(1-100%)
(1-100%)
(1-?%)
(1-?%)
YES
YES
COMM LOSS DELAY
COMM LOSS DELAY
(60 SEC)-OK?
(60 SEC)-OK?
YES
YES
NO
NO
(0-4095)
(0-4095)
* If POSITION is chosen, as action,
* If POSITION is chosen, as action,
this menu will appear.
this menu will appear.
YES
YES
(2%)
(2%)
NO
NO