roco Z21 10808 Manual page 16

Configuration using the Z21 maintenance tool
Note: only possible via the CAN-BUS and with at least maintenance version 1.12 and Z21
firmware 1.30.
Connect the Z21 detector to the Z21 via the CAN-BUS and provide the track inputs P and N on the Z21
GB
detector with the track voltage from the control centre.
The Z21 detector is configured in the "Z21 Maintenance Tool" software as follows:
After you have connected the Z21 detector correctly and have clicked on the "Status anfordern" (Request
status) button on the CAN tab, an own panel is inserted for each of the detected CAN modules. The NetID
is a unique identifier of the CAN module
You can now see which track sections are occupied, in addition to the locomotive address and the rerail
direction. (Note: only works with locomotives that are RailCom
16
8010808920.indd 16
-compatible).
®
29.08.2017 11:51:42