Before Installation; Receiving Equipment; Rating And Certifications - Rheem Raypak R207A Installation And Operation Manual

3. BEFORE INSTALLATION

Receiving equipment

The manufacturer recommends that this manual be
reviewed thoroughly before installing the pool/spa heater. If
there are any questions that this manual does not answer,
please contact the factory or your local representative.
On receipt of your equipment it is suggested that you
visually check for external damage to the carton. If the
carton is damaged, a note should be made on the Bill
of Lading when signing for the equipment. Remove the
heater from the carton. If it is damaged, report the damage
to the carrier immediately. Save the carton.
These items are shipped inside a box in the carton with
the heater:
Standard Unit (POLYMER HEADERS)
1. "Pagoda" top
2. 2" CPVC union half with "O" rings (2)
3. Plastic pipe finish flange for gas line
4. Bonding lug with mounting screw
ASME Unit (BRASS HEADERS)
1. "Pagoda" top
2. 2" CPVC union half with "O" rings (2)
3. Plastic pipe finish flange for gas line
4. Bonding lug with mounting screw
5. Pressure Relief Valve
6. ProTek Shield Adapter with ProTek Shield Assembly
and wing nut
THE MODEL AND SERIAL NO.
CAN ALSO BE FOUND INSIDE
THE BEZEL ABOVE THE DISPLAY
MODEL AND SERIAL NO.
LOCATED ON RATING PLATE
Figure 1. Rating Plate Location
6
Be sure that you receive the number of packages indicated
on the Bill of Lading.
Model Identification Number
The model number of a pool heater can be found on the
Sales Order and the pool heater rating plate. The example
below identifies what the characters of the model number
represent.
B - _ 207A - E N - C # 26
† For commercial installations, ASME-Certified.
† † Units with polymer headers do not meet building code requirements for
commercial installations. Consult local code authorities before using any
unit with polymer headers in a commercial environment.
When ordering parts, you must specify the model and
serial numbers of the heater. See Figure 1 for location of
serial number. When ordering under warranty conditions,
you must also specify date of installation.
Figure 2. Model and Serial Number

Rating and certifications

These heaters are design-certified and tested under the
latest requirements of the ANSI Z21.56 / CSA 4.7 Standard
F10639-1
for Gas-Fired Pool Heaters. All heaters can be used either
indoor or outdoors when appropriate venting is installed.
The appropriate top designated for each type of use is
#
Burner Orifice Size
C
Copper tubes
X Cupronickel tubes
N Natural gas
E
Electronic ignition
207A input 199,500 BTUH (58.4 kw)
267A input 266,000 BTUH (77.9 kw)
337A input 332,500 BTUH (97.4 kw)
407A input 399,000 BTUH (116.9 kw)
_ Brand designation with letter
Bronze headers †
B
Polymer headers † †
P
(for residential use ONLY)
Model:
P-R 207A-EN-C #26
POLYMER
Fuel: Ignition
NAT IID
Item Number:
009240
Serial Number:
91001010
Note:
Serial No.