Greenlee FishFinder Plus FF200 Instruction Manual page 4

Important Safety Information
Electric shock and fire hazard:
• Do not use in explosive atmospheres such as in the presence of flammable liquids, gases, or
heavy dust.
• Do not expose this unit to rain or moisture.
• Do not use the unit if it is wet or damaged.
• Inspect the tool or accessory before use. They must be clean and dry, and the insulation must
be in good condition.
• Do not use probe if it is cracked, dirty, wet, or contaminated with a foreign substance.
• Destroy optical cable and replace immediately if insulation found on the cable is cut or
damaged. (Yellow underlayer on the cable serves as a warning that the orange outer layer
has been compromised.)
• Use this unit for the manufacturer's intended purpose only, as described in this manual. Any
other use can impair the protection provided by the unit.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
• Never make bodily/personal contact beyond the retention shield located at the base of the
optical cable connector when in use on or near potentially energized objects.
• Always keep fingers behind the barrier during use.
• Do not expose to corrosive chemicals.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
• Always test the circuit or equipment to ensure it is de-energized before using the hook,
magnet, or mirror.
• To avoid electrical shock, the hook, magnet, or mirror must be used on de-energized circuits
only.
Failure to observe these warnings could result in severe injury or death.
Electric shock hazard:
• Do not operate with the case or battery compartment open.
• Before opening the case or battery compartment, remove the tool from the circuit and shut
off the unit.
Failure to observe these warnings could result in severe injury or death.
4