Cambridge Audio CXC Manual page 4

WEEE SYMBOL
The crossed-out wheeled bin is the European Union symbol
for indicating separate collection for electrical and electronic
equipment. This product contains electrical and electronic
equipment which should be reused, recycled or recovered
and should not be disposed of with unsorted regular waste. Please return
the unit or contact the authorised dealer from whom you purchased this
product for more information.
CE MARK
This product complies with European Low Voltage (2014/35/
EU), Electromagnetic
Environmentally-friendly design of Energy-related Products (2009/125/
EC) Directives when used and installed according to this instruction
manual. For continued compliance only Cambridge Audio accessories
should be used with this product and servicing must be referred to
qualified service personnel.
RCM (REGULATORY COMPLIANCE MARK)
This product meets Australia, New Zealand Safety, EMC and
Radio Communications requirements of the ERAC and ACMA.
CU-TR MARK
This product meets Russia, Byelorussia and Kazakhstan
electronic safety approvals.
FEDERAL COMMUNICATIONS COMMISSION
Supplier's declaration of conformity (SDoC)
Equipment: COMPACT DISC TRANSPORT
Model: CXC
Trademark: Cambridge Audio
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The responsible party in US:
Company name: Audio Partnership LLC
Address:
1913 N Milwaukee Ave. Chicago, IL 60647
Phone: (312) 636-4817
Legal Representative Person:
Gregg Chopper
Signature:
Compatibility (2014/30/EU)
FEDERAL COMMUNICATIONS COMMISSION NOTICE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses, and can radiate radio frequency energy,
and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
and
the user is encouraged to try and correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this equipment.
MODIFICATIONS:
The FCC requires the user to be notified that any changes or modifications
to this device that are not expressly approved by Cambridge Audio, may
void the user's authority to operate the equipment.
PLUG FITTING INSTRUCTIONS (UK ONLY)
The cord supplied with this appliance is factory fitted with a UK mains
plug fitted with a 3 amp fuse inside. If it is necessary to change the fuse,
it is important that a 3 amp one is used. If the plug needs to be changed
because it is not suitable for your socket, or becomes damaged, it should
be cut off and an appropriate plug fitted following the wiring instructions
below. The plug must then be disposed of safely, as insertion into a mains
socket is likely to cause an electrical hazard. Should it be necessary to fit a
3-pin BS mains plug to the power cord the wires should be fitted as shown
in this diagram. The colours of the wires in the mains lead of this appliance
may not correspond with the coloured markings identifying the terminals
in your plug. Connect them as follows:
The wire which is coloured BLUE must be connected to the terminal which
is marked with the letter 'N' or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal
which is marked with the letter 'L' or coloured RED.
The wire which is coloured GREEN/YELLOW
must be connected to the terminal which is
marked with the letter 'E' or coloured GREEN.
If a 13 amp (BS 1363) plug is used, a 3 amp fuse
must be fitted, or if any other type of plug is
used a 3 amp fuse must be fitted, either in the
plug or adaptor, or on the distribution board.
E
GREEN/
YELLOW
FUSE
BLUE
N
L
BROWN
CORD
GRIP