Download  Print this page

Sharp PN-ZW01 Operation Manual

Hide thumbs
   

Advertisement

Operation Manual Wireless Adapter
Applicable models
LCD MONITOR
(as of April 2018)
PN-B401/PN-B501/PN-M401/PN-M501
Available models differ according to region.
CAN ICES-3 (A) / NMB-3 (A)
Thank you for purchasing a SHARP product.
Before using the product, please be sure to read this operation manual carefully. Before using the product, be sure to read and understand the "SAFETY
PRECAUTIONS" in the operation manual of the LCD MONITOR. After reading the manual, keep it in a convenient location where it can be accessed
at any time. As for how to use the product, refer to the manual of the LCD MONITOR.
TIPS
- This product was shipped after strict quality control and inspection; however, if breakage or a malfunction should be found, contact your SHARP dealer
or your nearest customer contact.
- Please understand that SHARP CORPORATION bears no responsibility for errors made during use by the customer or a third party, nor for any other
malfunctions or damage to this product arising during use, except where indemnity liability is recognized under law.
- This product and its accessories may be upgraded without advance notice.
IMPORTANT:
To aid reporting in case of loss or theft, please record the product's model
and serial numbers in the space provided. The numbers are located in the
rear of the product.
WARNING:
FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the
user's authority to operate this equipment.
NOTE:
This equipment has been tested and found to comply with the limits for Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This device complies with Part 15 of FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of this device.
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF)
Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that are deemed
to comply without testing of specific absorption ratio (SAR).
WARNING:
This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take
adequate counter measures.
Model No.:
Serial No.:
PN-ZW01
U.S.A. ONLY
U.S.A. ONLY
U.S.A. AND
CANADA ONLY

Advertisement

Table of Contents

   Related Manuals for Sharp PN-ZW01

   Summary of Contents for Sharp PN-ZW01

  • Page 1: Fcc Caution

    - Please understand that SHARP CORPORATION bears no responsibility for errors made during use by the customer or a third party, nor for any other malfunctions or damage to this product arising during use, except where indemnity liability is recognized under law.
  • Page 2 (g) Approx. 0.022 (10) Wireless LAN Settings As a part of our policy of continuous improvement, SHARP reserves the When you have finished updating the firmware, follow the steps below to right to make design and specification changes for product improvement configure the wireless LAN settings on the LCD monitor.

Comments to this Manuals

Symbols: 0
Latest comments: