Related Manuals for SI LinkPro
Summary of Contents for SI LinkPro
- Page 1 Screen Innovations LinkPro 9715-B Burnet Rd, Suite 400 Austin, TX 78758 Installation Instructions 512.832.6939 www.screeninnovations.com v. 1.2 4 October 2019 DOC.#400066 Copyright 2019 US SHADE CORPORATION...
-
Page 2: Initial Considerations
Other nearby transmitters may also cause interference. LinkPro Thank you for purchasing an SI product. If you have any questions or need any assistance with your LinkPro, we would love to help you. -
Page 3: Parts In The Box
(2) Original Mounting Screws (PH2) Ring Screws (PH2) (1) 2 Meter CAT5e (2) Drywall (1) 48v Passive PoE Anchors (1) 48v Passive PoE Injector - Brick Injector - Wall Wart LinkPro - Parts in the Box LinkPro - Parts in the Box... - Page 4 (preferred) 3/4" hole for NOTE: Original Mounting Ring installation process is CAT5e/6 similar to Magnetic Mount. For more details contact support. 2. Mark the mounting hole locations (these holes are (cont. to next page) LinkPro - Installation LinkPro - Installation...
- Page 5 4. Gently drive the drywall anchors into the 7/32" holes. 6. Plug in the LinkPro and align the magnets on the Locate your CAT5e/6 cable and pass it through the back of the device with two of the recessed areas hole drilled.
- Page 6 7. There should be an audible click. (cont. to next page) LinkPro - Installation LinkPro - Installation...
- Page 7 (sold seperately)/ PoE injector (incl.) Use a thin tool (eg. paperclip) to hold down the reset button on the side of the LinkPro (LED will turn red) for approximately 20 seconds, or until the LED turns off. Plug it into PoE/...
- Page 8 9. Press “Create Group” and repeat steps 6 - 8 for all of the shades in the room. 2. Power your LinkPro using a PoE switch or the 10. Name the group (this will be used for Amazon provided PoE injector, and wait until the LED on the Alexa).
-
Page 9: Fcc Information
Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver FCC INFORMATION Connect the equipment into an outlet on a circuit different This device complies with Part 15 of the FCC Results. from that to which receiver is connected. Consult the dealer Operation is subject to the following two conditions: or experienced radio technician for help.
Need help?
Do you have a question about the LinkPro and is the answer not in the manual?
Questions and answers