Exitronix TRL Series Installation Instructions

Download this manual

TRL Series

Installation Instructions

READ AND FOLLOW ALL SAFETY INSTRUCTIONS.

When using electrical equipment, basic safety precautions should always be followed including the following:

• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.

• Installation and servicing of this equipment should be performed by qualified service personnel only.

• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations

if applicable.

• Do not mount near gas or electrical heaters.

• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering

by unauthorized personnel.

• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.

• Any modification or use of non-original components will void the warranty and product liability.

• Do not use this equipment for other than intended use.

• Allow battery to charge for 24 hours before first use.

10070085 REV 1 - 11/19

IMPORTANT SAFEGUARDS

SAVE THESE INSTRUCTIONS!

Technical Support

■ (623) 580-8943 ■ technicalsupport@barronltg.com

800-533-3948 www.barronltg.com

Need help?

Do you have a question about the TRL Series and is the answer not in the manual?

Page 1 TRL Series Installation Instructions IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS. When using electrical equipment, basic safety precautions should always be followed including the following: • DISCONNECT AC POWER SUPPLY BEFORE SERVICING. • Installation and servicing of this equipment should be performed by qualified service personnel only.
Page 2 TRL Series Installation Instructions LED Module Replacement LED module with 11W high performance power LED. If need, please contact factory. Function: 1. For normal lighting use, the fixture can be configured for automatic operation by the built-in daylight photo sensor or can be switched through an external switch.
Page 3 TRL Series Installation Instructions Fig. 4 Fig. 6 Align First Quick Connectors Battery Connector Fig. 5 Installation: Fig. 1 Open the front cover Fig. 2 Install using J-box. Fig. 3 Install using conduit. Fig. 4 Wire diagram for photo sensor.
Page 4 TRL Series Installation Instructions Installation: Fig. 2 Fig. 3 Fig. 1: Heater pad introduce Fig. 2: Installation battery to heater pad. Fig. 3: Installation heater pad. Fig. 4: 120V heater pad wiring diagram Fig. 5: 277V heater pad wiring diagram...