Advertisement
This guide provides information for installing and programming the TeleSMART system.
TeleSMART works in conjunction with the following control panels and keypads:
Controls: VISTA-10SE, VISTA-20SE*, VISTA-50P*
*when used in single-partition installations only
Keypads: 6162, 6139T (controls TeleSMART
†
To access TeleSMART features, these keypads must be connected to the
TeleSMART module. Keypads used only for security system functions should be
connected to the security system's keypad terminals.
The TeleSMART system provides a voice interface for an ADEMCO security system and the
TeleSMART phone system. It has the following features:
• 4 unique mailboxes for storing messages
• 6 user access codes
• Security system interface
• Memo feature for leaving messages for other users
• Caller ID capabilities for up to 25 phone numbers
• Memory (speed) dialing for up to 15 phone numbers
• Repeat dialing (automatically redial busy numbers)
• Last number redial
• Call screening (with and without Caller ID)
• Privacy (turn off the ringer)
• Remote access of TeleSMART and security system
The TeleSMART Module should be mounted in the security system's control cabinet if space is
available, or within a grounded metal enclosure to provide proper ESD protection.
Mounting Inside the Use double-sided tape to attach the module to the interior surface
Control's Cabinet: of the cabinet, or hang it on two screws. Do not mount it on the cabinet door
or attach it to the control's PC board.
Mounting Outside
Use the screw holes at the rear of the module. Wires can be
the Cabinet:
brought out from the side or back (use the round breakout on the back).
Affix the supplied Summary of Connections label to the module's inside cover or to the inside of
the cabinet door.
†
and security system functions)
– 3 –
Advertisement
