Table of Contents
Advertisement
5.3.4
Head alignment adjustment
1)
Equipment
CE Tester
CE Diskette (DYMEK 502-ID STANDARD DISKETTE)
Oscilloscope
Hex wrench (2.0 mm dia.)
(Fine point diagonal cutter)
2)
Adjustment procedure
2)-1
2)-2
2)-3
2)-4
2)-5
3)
Note:
Connect CE Tester to Drive (set power off).
Turn-on power switch and motor on.
Select drive and load CE diskette (close clamp
door slowly).
Seek TK00 to TK32 then read amplitude of each
waveform (positioning waveform) at T?A9, TFA10
under read mode (see Figure 7).
EXT - +INDEX
Trigger:
Sianal :
CHI
CH2 - TPA10
Specification:
when
A > B
A < B
In each case of seek direction is TK00 to TK32
or TK79 to TK32, loosen carriage set screw,
then adjust Carriage Assy until signal comes
within specification.
the screw.
Adjust under following conditions
Temperature:
Humidity
:
(DC, +)
TPA9
(AC, Normal)
-
(AC ,
CHECK
B/A >0.57
A/3 > 0.57
Do not forget to tighten
23°C =2°C exposed over 2 hours
50% :5¾
(TPB14)
Add
Inverted)
ADJUST
0 .6
0.6
Advertisement
Chapters
Table of Contents
