Advertisement
Installation Instructions:
EMG Model: Pi2 Phase Inverter
The Pi2 is installed on guitars with two or three pickups. It is shown installed
directly at the output of either one of the pickups. The first few diagrams
show installations for two pickup guitars. The Pi2 is always wired in series
with the signal chain and can be installed on either pickup. On a two pickup
guitar the resultant sound will be the same. Since there are so many
ways to wire a guitar there are only a few diagrams shown.
If the diagram you need isn't shown, use any of the existing EMG Wiring
diagrams and simply place the Pi2 in series with either pickup similar
to the diagrams shown.
Diagram #2
Volume / Volume / Pi2
Master Tone (Active)
BRIDGE PICKUP
NECK PICKUP
Diagram #3
Volume / Volume / Pi2
Master Tone (Passive)
BRIDGE PICKUP
NECK PICKUP
Pi2 Instructions Page 2
NOTE REVERSED
CONNECTOR
NK VOLUME
NOTE REVERSED
CONNECTOR
NK VOLUME
Note: Reversed connector! Pins 1 and 2 are reversed.
Diagram #1
Pi2
BR VOLUME
Pi2
- 9V +
BR VOLUME
All of the EMG Active controls use the same 5-pin connector
shown below.
Make sure the connectors are plugged on as shown.
- 9V +
NOTE REVERSED CONNECTOR
ACTIVE TONE
(VLPF)
OUTPUT CABLE
MASTER
TONE
OUTPUT CABLE
BATTERY
BUSS
OUTPUT
R
S
T
BATTERY
BUSS
OUTPUT
R
S
T
Advertisement
