Page 2
Massive Audio does not recommend installing DRAGO Series Amplifiers without the help of a certified installer and does not warranty this amplifier for abuse caused by mis-installation. Please have your installer consult with this user manual before installation. Discon ons.
Page 3
1) INPUT (RCA) Connect preamp signal cables from the head unit to the RCA input of the amplifier. Minimum level input of 0.4V - 10V maximum is essential for correct operation. 2) SPEAKER INPUTS This is a MONO input. Make sure the correct polarity and impedance is used. Depending on the design and output of the system we recommend using a minimum 12 AWG.
Page 4
SPEAKER INPUTS Amplifier connection to the loudspeakers. Minimum speaker gauge is 12 AWG. Minimum speaker impedance is 1 Ohm.
Page 6
• Do not leave your Massive Audio Amplifier in direct sunlight for extended periods of me. • Do not leave your Massive Audio Amplifier near open flames such as cooking burners, candles, or fireplaces. • Do not block any ven la on openings.
Page 7
7,840 Watts 13,450 Watts 19,050 Watts S power, 1 ohm mono ---------------------------------------- 24,192 Watts -RMS power, 1 ohm @ 18 volts ---------------------------------- 18 Volts operation with actual SPEAKER LOAD only Signal To Noise Ratio ---------------------------------------------------- >90dB 80Hz ~ 12KHz Low P High Pass Frequency Crossover 10Hz ~ 270Hz Band Pass Frequency Crossover...
Page 8
2018 MASSIVE AUDIO INC. Designed in the U.S.A Made in Brazil...
Need help?
Do you have a question about the DRAGO Series and is the answer not in the manual?
Questions and answers