Leister Groover Operating Instructions Manual page 6

OPERATION
Operating condition
• Adjust the tracking wheel (11) with spacers (12) to the pitch as required when
using nap-rolls, or tiles.
• Fit the ejector pipe (16) and dustbag (17).
• Adjust the groove depth.
– With your left hand push down the handle (5) of the drive unit up to the magnet
stop.
– With your right hand on the control knob (8) adjust the required groove depth
until approx. 3/4 of the material thickness is visible on the scale.
•
Caution: Cutting blade can protude!
• Align the tool along the grooving line via the adjustable guide roller (9) and the
red positioning arrows (22). Pay attention to the direction of cutting!
Operation
• Connect tool to the power supply.
• Cutting speed switch (4) set to position 1 or position 2 depend from material
thickness.
• Hold the groover by the handle (5) (left hand) and by the hand rest (6) (right
hand).
• Align the marking arrows on the tool (red) with the grooving line. The adjustable
guide roller (9) should run inside the grooving line and the rear roller (10) in the
groove.
• Activate the locking button(3). Switch on the operating switch (2).
• Press the handle down to the magnet stop (grooving position).
• The Groover is easy to push forward and straight along the grooving line with
the adjustable guide roller (9) and the rear roller (10).
• At the end of the groove, switch off the operating switch (2) and release the
handle (5). The tool will spring back into the starting position.
Caution: The cutting blade run out !
• If required set the guide roller (9) with the locking screw (21) and adjustment
screw (20) (grooving centre).
Changing the cutting blade
•
Caution: Unplug the tool !
• Remove the cutting blade cover (14).
• Remove the blade with a box spanner.
• Clean the hub of the tool as well as the cutting blade to be inserted.
• Insert and fit the cutting blade. Check that the cutting blade revolves freely.
• Refit the cutting blade cover (14).
6
LEISTER Groover