Table of Contents
Advertisement
1. Unit Name
Up to a 31 character unit name can be assigned to the VoIP Tower Phone being programmed.
2. SIP Server
Enter the IP address of your SIP server or service provider in this field. NOTE: If outbound proxy is not required, enter
the SIP server IP address into the Outbnd Proxy field.
3. Peer to Peer Settings
When set to Peer to Peer mode a SIP server is not used. The unit should be programmed with a Static IP Address and
Username, a password is not used. Caller ID can be programmed if needed. Simply call the unit by entering the
programmed "username@192.168...(Static IP address for the unit)". The static IP address is normally programmed into
a page button on the VoIP telephones.
4. Outbound Proxy
If your SIP provider requires an outbound proxy IP address enter it in the Outbnd Proxy field. If outbound proxy is not
required enter the SIP sever IP address into the Outbnd Proxy field. NOTE: If not required, this field must match your
SIP server IP address.
5. Authentication ID
If your SIP provider requires Authentication ID, enter it in the Authentic. ID field. If Authentication ID is not required,
leave this field blank.
6. Register Fails (Re-Resolve or Alternate Server)
When registered to a SIP server in the event that registration is lost you can program the unit to re-resolve using the
current SIP server IP address or route pages through an alternate SIP server. With Alternate Server selected enter the
IP address of the alternate SIP server in the field next to the Register Fails drop down box. NOTE: The maximum length
of the SIP server address is 75 characters.
Programming Features
13
Advertisement
Table of Contents
