Advertisement
INSTRUCTIONS FOR INSTALLATION AND USE.
3. DISPLAYS
At the power up the unit shows "---" during 3 seconds approximately during which it performs a self-check, then the current
value according to the configuration set appears. If SIM is different from 0 it's possible to display the instantaneous value by
pressing
+ .
LTS12 permanently stores the minimum and maximum values measured during the normal operation. The stored values are
displayed by respectively pressing button
or
and cleared by pressing button
for 1 second.
If the readout exceeds the limits programmed with LOR and HOR, then "or" is displayed, while in case of probe failure the
indication "PF" appears.
4. RE-CALIBRATION
Should it be necessary to re-calibrate the unit, then act in the following way: get an accurate calibrator to be connected to
the LTS12 input; then get into the unit configuration (see paragraph 2), and select parameter LAD or HAD. First act on LAD
then on HAD. LAD allows 0 calibration (32°F if SCL=02) by adding a constant offset all over the range; HAD allows span
calibration with a proportional offset between the calibration point and 0. After having selected the desired value, press
to display the measured value and adjust it with
+
or
.
WARRANTY
LAE electronic Srl warrant that their products are free of any defects in workmanship and materials for a period of 1 (one) year from date of production shown on
the enclosure. LAE electronic Srl shall only repair or replace those products of which defects are due to LAE electronic Srl and recognised by their technicians. LAE
electronic Srl are not liable for damages resulting from malfunctions of the products.
Defects due to exceptional operating conditions, misapplication and/or tampering will void the warranty.
All transport charges for returning the product to the manufacturer, after prior authorisation by LAE electronic Srl, and for the return to the purchaser are always for
the account of the purchaser.
Advertisement
