LOCKEY USA M210EZ Installation Instructions

2
3
7 8
16 17
5 6
16 17
4
10 11 13
9
Step 1: Change User Code/Combination (OPTIONAL)
To change user code/combination, see instructions on reverse side.
Step 2: Identify Door Handing
(The M210EZ is pre-handed for right-hand doors)
Right-Hand Doors – From exterior of door, hinges are on right-side (Fig. 1).
Left-Hand Doors – From exterior of door, hinges are on left-side (Fig. 2).
To change handing for left-hand doors, use a #1 phillips screwdriver to remove
two blue screws and cover plate from Outside Body (Fig. 3).
Move the handing pin from the right side of the Outside Body to the hole on the left side.
Replace plate and screws.
*M210EZDC – Inside Body must be handed opposite from Outside Body.
Step 3: Place Outside Body on EZ Plate A
Place Rubber Trim Plate (#3) on EZ Plate A (#15).
Place the Outside Body (#1) on EZ Plate A and screw into place with two (2) M5 x 1/2" screws (#18).
Step 4: Install Brass Support Pin (Fig. 5)
Install Brass Support Pin (#14) into EZ Plate B (#15) on either side.
Step 5: Adjust Deadbolt (if necessary) & Install
Adjustable Deadbolt (#12) is preset to 2 3/8" backset.
To adjust, lift pin and slide to 2 3/4" (Fig. 6).
With arrow pointed UP, insert Deadbolt and secure with two (2) Wood Screws (#9).
15B
18
9
14
12
18
9

INSTALLATION INSTRUCTIONS:

Continued on Reverse Side
Digital M210EZ Deadbolt
Installation Instructions
M210EZ |
Inside Body M210EZDC:
15A
3
1
DC= Double Combination
M210EZDC
No. Part Name
1 Outside Body
2 Inside Body
3 Rubber Trim Plate
4 Mortised Strike
5 Spindle 40-55mm.
6 Spindle 30-45mm.
7 Machine Screw M4 x 12mm
Machine Screw M4 x 25mm (DC)
8
Wood Screw M4
9
Extra Code Tumblers (Red)
10
Extra Non-Code Tumblers (Blue)
11
12 Adjustable Deadbolt 2 3/8" - 2 3/4"
13 Tweezers
14 Brass Support Pin
15 EZ Mounting Plates (A
16 Machine Screw M4 x 35mm
Machine Screw M4 x 17mm
17
Machine Screw M5 x 1/2"
18
Fig. 4
Fig. 5
LIFT
Fig. 6
M210EZ
1
1
2
1
1
1
2
2
4
1
2
1
1
1
2
B)
&
2
2
2
Fig. 3
SLIDE