Advertisement
fig.2
3.3.
Recharging Using the Vehicle Charger.
Note: Always use the mains charging facility in preference to vehicle charging when
available.
3.3.1.
Start the vehicle engine.
3.3.2.
Plug one end of the power lead (Fig.3) into the 12Vdc socket (Fig.2) on the unit and
the other end into the vehicle vehicle accessory outlet.
3.3.3.
Depress the test button once every hour to check the power level.
WARninG! DO nOT OVERCHARGE
3.3.4.
The Vehicle Charging method is not an automatic charging method. Frequent
monitoring of the charging process is the only safe way of ensuring the unit is
not overcharged.
4. OPERATiOn
WARNING! YOU MUST FOLLOW SAFETY INSTRUCTIONS AND ENSURE THAT THE
ROADSTART AND VEHICLE VOLTAGES ARE THE SAME.
4.1.
Vehicle Battery Charging
nOTE: Some vehicle ignition systems must be turned to "Accessory" to activate the vehicle accessory socket. A defective battery may not
accept a charge from the portable power source.
4.1.1. Plug one end of the power lead (Fig.3) into the RoadStart unit.
4.1.2. Plug the other end into the vehicle accessory socket.
4.1.3. Allow the battery to charge for thirty minutes.
4.1.4. Remove the power lead and start the vehicle.
4.2
Emergency Jump Starter
nOTE: For optimum performance, the unit should not be stored below 10°C when using the unit as a jump starter.
4.2.1. Turn off the vehicle ignition.
4.2.2. Ensure voltage selector switch is in 'OFF' position.
4.2.3. Attach the RED (positive +) clamp to the positive terminal of the battery.
4.2.4. Attach the BLACK (negative -) clamp to the vehicle chassis.
4.2.5. If the alarm buzzer sounds, it indicates that the connections are crossed: remove clamps and replace them to the correct connections.
4.2.6. Ensure that all cables are clear of moving belts and rotating fans.
4.2.7
Select either 12V or 24V with the voltage selector switch.
4.2.8. Maintain a safe distance from the battery whilst jump starting.
4.2.9. Turn on the ignition to start the vehicle.
nOTE: If the vehicle does not start after 6 seconds, allow the RoadStart unit to cool for 3 minutes, before attempting to jump start the vehicle
again. If this is not done, the unit could sustain damage.
4.2.10. When the vehicle has started, disconnect the Roadstart from the vehicle as quickly as possible.
4.2.11. Return the clamps to the side storage lugs.
in THE EVEnT OF inADVERTEnT COnnECTiOn TO 24VOLT SYSTEM WiTH THE SELECTiOn in THE 12VOLT POSiTiOn
DO nOT TOUCH THE VOLTAGE SELECTOR SWITCH.
DiSCOnnECT THE BATTERY, NEGATIVE TERMINAL FIRST, AND LEAVE THE ROADSTART UNIT TO REST FOR AT
LEAST ½ HOUR.
DAnGER OF EXPLOSiOn, WHiCH COULD RESULT in DAMAGE AnD inJURY, iF THE ABOVE inSTRUCTiOnS
ARE nOT OBSERVED.
If the RoadStart is connected to the incorrect voltage, it is recommended that it is returned for inspection BEFORE being used again.
© Jack Sealey Ltd
fig.3
Original Language Version
fig.4
RS125 V2
Issue: 1 - 11/12/12
Advertisement
