Speaker Beep For Incoming Call; Balanced/Unbalanced Switch; Sidetone Trimmers; Headset Connector Notes - Audiocom SS-1002 Technical Manual

Speaker Beep for Incoming Call

To set the speaker beep for incoming calls, do the following:
> Set DIP switch 5 to the closed position if you want to hear incoming call beep in the speaker.
NOTE: DIP switch 3 must be in the open position.

Balanced/Unbalanced Switch

This switch is set at the factory to the Balanced (BAL) position for use with Audiocom intercom systems. Set the switch to the
Unbalanced, or UNBAL position for use with a Clear-Com intercom system.

Sidetone Trimmers

The Sidetone Trimmers are normally adjusted after all connections are completed. See "Sidetone Adjustment" on page 15.
DIP Switch location RM version (left), SIP switch location S, U, and P Versions (right).
FIGURE 3.

Headset Connector Notes

If you are using a monaural, dynamic-mic headset, or a monaural, telephone-style, dynamic-mic hands-free, or a handheld
dynamic microphone, plug it into the headset connector. You can also use this connector with monaural headphones for
listening when you are using either the built-in panel microphone or the optional gooseneck microphone for talk back.

Panel Mic Connector Notes

As an alternative to a headset or telephone style handset, you can use either the built-in panel microphone or an optional
gooseneck microphone.
To connect a Telex MCP-90 gooseneck microphone, do the following:
Insert the 1/4" RTS connector into the panel microphone connector.
1.
Screw the microphone in.
2.
9