Connecting The Water Inlet Hose - LG FC1409D4E Owner's Manual

3
Stick the adhesive side a of the anti-slip sheet
on the floor.
• It is most effective to install the anti-slip
sheets under the front feet. If it is difficult to
place the sheets under the front feet, place
them under the back feet.
4
Make sure that the appliance is level.
• Push or rock the top edges of the appliance
gently to make sure that the appliance does
not rock. If the appliance rocks, level again.
16
Connecting the Water Inlet
Hose
Note for Connection
• Water pressure must be between 100 kPa
and 1000 kPa (1.0 - 10.0 kgf/cm²). If the
water pressure is more than 1000 kPa, a
decompression device should be installed.
• Do not overtighten the water inlet hose to all
valves.
• Periodically check the condition of the hose
and replace the hose if necessary.
Checking the Rubber Seal on the
Water Inlet Hose
Two rubber seals a are supplied with the water
inlet hoses. They are used to prevent water leaks.
Make sure that the connection to taps should be
sufficiently tight.
Connecting the Hose to Water
Tap
Connecting Screw-Type Hose to Tap with
Thread
Screw the hose connector onto the water supply
tap. Hand tighten only with the aid of a soft cloth.
EN