Subscribe to Our Youtube Channel
Related Manuals for Elenco Electronics BS100
Summary of Contents for Elenco Electronics BS100
- Page 1 All manuals and user guides at all-guides.com BUTT SET MODEL BS100 Instruction Manual Elenco ® Electronics Inc. Copyright © 2000 Elenco ® Electronics Inc.
- Page 2 All manuals and user guides at all-guides.com INTRODUCTION The BS100 is designed for the installers, repair technicians, and other authorized personnel for line testing and temporary communications. The test set employs the latest in integrated circuit design to provide DTMF (Touch Tone ) and dial pulse output.
-
Page 3: Specifications
All manuals and user guides at all-guides.com SPECIFICATIONS ELECTRICAL Loop Resistance less than 300Ω (talk mode) Monitor Impedance greater than 100kΩ ROTARY DIAL OUTPUT Pulsing Rate 100pps +/– 0.8% Make Rate 33 +/– 3% Minimum Pose 600ms over DTMF OUTPUT Frequency Deviation +/–... - Page 4 All manuals and user guides at all-guides.com PHYSICAL DESCRIPTION (See Figure 1) 1. Receiver 2. Mega Ohm (MΩ Ω ) meter 3. Company logo 4. TONE/PULSE: On/Off switch for pulse or tone. 5. CALL: On/Off switch. Off position for MΩ insulation meter and On for subscriber calling with the METER/CALL switch.
- Page 5 All manuals and user guides at all-guides.com FRONT BACK Figure 1...
- Page 6 All manuals and user guides at all-guides.com OPERATION INSTRUCTIONS PLACING A NORMAL CALL A calling signal is sent to the subscriber's telephone causing it to ring. 1. Set to data safe mode by pressing the MON (9) switch. 2. Connect the alligator clips to L1 and L2 of subscriber side. 3.
- Page 7 All manuals and user guides at all-guides.com OPERATION INSTRUCTIONS (CON’T) REDIAL (RD) Will redial the last number entered. 1. Press the FS button for a new dial tone. 2. Press the RD button to redial the last number entered. Up to 32 digits can be redialed.
- Page 8 All manuals and user guides at all-guides.com INSULATION RESISTANCE & CAPACITY MEASUREMENT 1. Connect the alligator clips to L1 and L2 of subscriber side. 2. Push the TEST/CALL (10) button. 3. The insulation resistance will be displayed on the 'Mega Ohm meter, when the TEST/CALL button is pressed.
Need help?
Do you have a question about the BS100 and is the answer not in the manual?
Questions and answers