Related Manuals for Unimig RWX 6000
Summary of Contents for Unimig RWX 6000
- Page 1 2 YEAR WARRANTY UMCWH 0356 RWX6000 Helmet Manual MAY19.indd 1 8/05/2019 3:53:51 PM...
-
Page 2: Table Of Contents
CONTENTS SAFETY FEATURES HELMET BREAKDOWN FILTER DISPLAY ICONS OPERATING INSTRUCTIONS TROUBLESHOOTING NOTES RECOMMENDED SHADE SETTINGS 2 | RWX6000 Welding Helmet Manual 0356 RWX6000 Helmet Manual MAY19.indd 2 8/05/2019 3:53:51 PM... -
Page 3: Safety
• If this lens does not darken when striking arc, stop welding immediately and check the helmet is in Weld Mode and not Grind Mode. If the issue persists, contact your local UNIMIG Service Department. -
Page 4: Features
FEATURES The RWX6000 Welding Helmet is equipped with an automatic darkening filter. The filter is transparent before welding so that the operator may observe the work surface clearly. When striking the arc, the filter darkens automatically immediately. When the arc goes out, the filter will become transparent again. -
Page 5: Helmet Breakdown
HELMET BREAKDOWN Description Description Helmet shell Delay button Positioning point for the segmental plate Sensitivity button Outer protection lens Shade button ADF cradle Headgear slider (with 3 slots) Magnifying lens holder Headgear screw (Short, on left) Retainer lock Headband tightness adjusting knob Auto filter Headgear connector Battery holder... -
Page 6: Filter Display Icons
FILTER DISPLAY ICONS 1. Battery Status 2. Welding Indication 3. Grinding Indication 4. Shade Range 5-9 5. Shade Range 9-13 6. Sensitivity indication: 7. Delay indication: 8. Shade reading 9. Memory selection 1 (low) to 5(high) 1 (short 0.1s) to 5 (long 0.9s) Note: Buttons on the left of the screen need to be pressed twice to start any settings. -
Page 7: Operating Instructions
• Choose an optimum Shade number for the required welding process or application. • If this lens does not darken when striking arc, stop welding immediately and check the helmet is in Weld Mode and not Grind Mode. If the issue persists, contact your local UNIMIG Service Department. - Page 8 OPERATING INSTRUCTIONS • Turn to 1 (0.1s): The time the ADF takes to lighten after welding becomes shorter. The shortest time is about 0.1s depending on the welding point temperature and shade setting. This setting is ideal for track welding or production welding with short welds. •...
-
Page 9: Helmet Shell
• The arc light must be visible completely by the sensor. If not, the filter will be transparent or unstable in darkness. • Please use the automatic filter at a temperature between -10°C-65°C (14°F-149°F ) • Do not disassemble the filter. If any problems arise, please contact your local UNIMIG service department. REPLACEABLE PARTS •... -
Page 10: Troubleshooting
90°. WARRANTY UNIMIG auto-darkening welding helmets are covered for warranty for up to two years from the date of purchase. The duration of use depends on various factors such as use, cleaning storage and maintenance. Frequent inspections are recommended. -
Page 11: Notes
NOTES RWX6000 Welding Helmet Manual | 11 0356 RWX6000 Helmet Manual MAY19.indd 11 8/05/2019 3:53:53 PM... -
Page 12: Recommended Shade Settings
RECOMMENDED SHADE SETTINGS 12 | RWX6000 Welding Helmet Manual 0356 RWX6000 Helmet Manual MAY19.indd 12 8/05/2019 3:53:53 PM...