Danner SP-155 Care And Operating Instructions

Submersible pump

Advertisement

WARRANTY

Danner pumps are warranted against failure due to defects in
materials and/or workmanship for 1 year from date of purchase. This
warranty covers defects occurring under normal use. The warranty
and remedies set forth herein are conditional upon proper installation,
use, maintenance, storage, and conformance with the applicable use.
It will be based upon Danner Mfg. discretion as to whether the defects
are of manufacturing origin. For warranty repair, return only the part
that is defective to our factory. Please include a dated proof of
purchase and $5.00 for postage and handling. Any damages due to
improper installation are not covered by this warranty. This warranty
does not apply to appearance or accessory items. This warranty does
not include damage due to handling, transportation, unpacking, setup,
installation, repair or replacement of parts supplied by any other than
Danner Mfg.; improper maintenance, modification or repairs by the
purchaser; abuse, misuse, neglect, accident, fire, flood, or other acts
of God. Any oral statements about this product made by the seller, the
manufacturer, their representatives or any other parties do not
constitute warranties and shall not be relied upon by the user and are
not part of this contract. Neither the seller nor the manufacturer shall
be liable for any injury, loss or damages, direct, incidental, or
consequential, including but not limited to incidental or consequential
damage for lost profits, lost sales, injury, and inability to use the
product and the user agrees that no other remedy is available. Before
using, the user shall determine the suitability of the product for their
intended use and the user shall assume all risk liability whatsoever in
connection therewith. To validate this warranty, keep your proof of
purchase (copy of sales receipt). Warranty covers the repair or
prorated replacement of the Danner Mfg. products. Danner Mfg.
denies all liability for any other loss including but not limited to loss of
equipment, income, livestock, vegetation or personal injury.
THE FOLLOWING VOIDS WARRANTY:
ALTERED OR CUT, PRODUCT LABELS ARE DEFACED OR
REMOVED.
PRODUCT
IS
MAINTAINED BY USER OR THEIR AGENT. PRODUCT IS ABUSED,
MISUSED, OR DAMAGED BY USER OR THEIR AGENT. PRODUCT
IS NOT REMOVED FROM SERVICE AND DRIED DURING
FREEZING CONDITIONS.
Distributed by: E G Danner Mfg. Inc.
Tel: 631-234-5261 or 800-458-5876
Email: sales@dannermfg.com
LINE CORD OR PLUG IS
IMPROPERLY
INSTALLED
OR
160 Oval Drive
Islandia, NY 11749
Fax: 631-234-7809 or 631-234-4778
Website: www.dannermfg.com
Danner
Submersible Pump
CARE AND OPERATING INSTRUCTIONS
Model
SP-155

INTRODUCTION

Thank you for purchasing this Danner water pump. This submersible
pump provides a continuous stream of water for submersible applications.
Danner pumps are carefully inspected and tested to insure both safety
and operating performance. However, failure to follow the instructions
and warnings in this manual may result in pump damage and/or serious
injury. Be sure to read and save this manual for future reference.

WARNING

Ensure that the electrical cord is looped below the electrical outlet to
form a "Drip Loop". This will prevent water from running down the cord
into the electrical outlet.
Risk of electric shock- This pump is supplied with grounding
conductor and grounding-type attachment plug. To reduce the risk
of electric shock, be certain that it is connected only to properly grounded
grounding-type receptacle.
Do not remove the grounding pin from the plug.
Do not connect to any voltage other than that shown on the pump.
The National Electric Code requires that a Ground Fault Circuit
interrupter (GFCI) be used in the branch circuit supplying fountain
pumps and other pond equipment. See your electrical supplies
dealer for this device.
To reduce the risk of electrical shock, use only on portable self -
contained fountains no larger than 5 feet in any dimension.
Do not use with water above 95°F (35°C)
The pump is to be supplied through a Residual Current Device
(RCD) with a rated residual operating current not exceeding 30mA.
CAUTION -
This pump has been evaluated for use with water only.
SAVE THESE
INSTRUCTIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SP-155 and is the answer not in the manual?

Questions and answers

Summary of Contents for Danner SP-155

  • Page 1 Model It will be based upon Danner Mfg. discretion as to whether the defects SP-155 are of manufacturing origin. For warranty repair, return only the part that is defective to our factory.
  • Page 2 CAUTION Always disconnect from electrical outlet before handling the  Remember: Monthly maintenance will add to your pump’s life. pump. Don’t operate without water.  Do not lift the pump by the power cord.  CARE AND MAINTENANCE Operate in clean water only. ...

Table of Contents