Download Print this page

EZ-ON 43YC Installation Instructions

Car cam with crotch strap

EZ-ON PRODUCTS

43YC

CAR CAM WITH CROTCH STRAP

IMPORTANT INFO

• Meets FMVSS213

• 43YC is for use by a passenger weighing 31 – 106

• You must use EZ-ON hardware tether kit (included) to install this conversion vest if the factory

installed tether anchor weight limit is less than the weight of the passenger or if there is no

tether anchor point available in your vehicle.

• Register this product to be notified for a safety recall

EZ-ON Products stands behind the products we make. Warranty covers any defects in material or workmanships under

normal use during the warranty period. We will repair or replace product defects for 1 year from manufacturer date.

WARNING

Death or serious injury can occur If manufacturer's instructions are not followed correctly.

All EZ-ON products are dynamically tested to meet NHTSA standards. Please follow washing

instructions on product tag. Replace product if it is damaged, frayed, or has been in a crash.

Recommended replacement after six years.

EZ-ON Products are not liable for injury if these recommendations are not followed.

one cut of the lap belt will allow the passenger to evacuate the vehicle.

When evacuating a passenger in an 43YC belt,

1-800-323-6598

www.ezonpro.com

Table of Contents

Do you have a question about the 43YC and is the answer not in the manual?

Page 1 • 43YC is for use by a passenger weighing 31 – 106 • You must use EZ-ON hardware tether kit (included) to install this conversion vest if the factory installed tether anchor weight limit is less than the weight of the passenger or if there is no tether anchor point available in your vehicle.
Page 2 1. Locate the tether anchor bracket. *Check the vehicle owner’s manual to locate factory installed tether bracket. *43YC tether strap can be turned one half twist to snap on difficult anchor locations. 2. Connect tether hook to tether anchor bracket directly behind passenger.