EasyPro Cabrio Lighting Series Instructions For Operation, Safety, Warranty

Color changing led light

Download this manual

Cabrio Color Changing LED Light

Instructions for Operation • Safety • Warranty

Thank you for purchasing EasyPro's Cabrio color changing LED light. With this

LED light you can illuminate a pond or waterfall, highlight a deck or patio and

extend the enjoyment of your entire landscape in the evening hours. This light is

fully submersible and may be used in or out of water.

Safety and Electrical Connections

Always disconnect the electrical supply before handling, maintaining,

repairing or installing any pond equipment.

2. Light must be attached to a 12 volt AC UL listed transformer.

3. Never connect the lights directly to a 110 volt or higher outlet.

4. Connect the transformer to a 110 volt receptacle that is protected by a

Ground Fault Circuit Interrupter.

5. Do not modify wiring in any way, quick plug ends must stay intact and

should not be replaced with terminals. DO NOT modify the white antenna on

the control module. Do not submerge control module.

6. All electrical work must be performed by a qualified technician. Always

follow the National Electrical Code (NEC) or the Canadian Electrical Code as

well as all local, state and provincial codes. Failure to follow manufacturer's

installation instructions may result in electrical shock, fire hazard, personal

injury or death, damaged equipment, provide unsatisfactory performance

and will void manufacturer's warranty.

Installation of LED Light

1. Before installing the product check for damaged or missing parts. Contact

EasyPro immediately if pieces are missing or damaged.

2. Be sure the power is disconnected before installing the light.

3. Determine desired location to place the LED light.

Note: Be sure to consider that individual diodes cannot be replaced at the

end of their life. Permanent settings may not be the best option in the case

that the entire LED fixture must be replaced.

CLED4

lighting series

by EasyPro Pond Products

Page 1 Cabrio Color Changing LED Light Instructions for Operation • Safety • Warranty Thank you for purchasing EasyPro's Cabrio color changing LED light. With this LED light you can illuminate a pond or waterfall, highlight a deck or patio and extend the enjoyment of your entire landscape in the evening hours. This light is fully submersible and may be used in or out of water.
Page 2 Installation of LED Light (continued) 4. Use with or without removable base to fit fixture into desired location. If base is used it may need to be ballasted to prevent fixture from shifting. 5. Run wire from LED fixture back towards control module and power source. 6.
Page 3 Changing the brightness or speed of a light cycle will reset the mode to the beginning of its cycle. • To operate multiple Cabrio fixtures use an EasyPro 12 volt AC transformer. Be sure not to exceed the total transformer wattage with any combination. • CLED4 - 3 Watts...
Page 4: Service And Maintenance
Limited warranty does not cover any cost associated with the installation or removal of the prod- uct subject to warranty claim. An RA number must be obtained by calling EasyPro Pond Products at 800-448-3873. It is your responsibility to pay the return shipping charges. Be sure to include the RA number, original receipt (in the form of an invoice or sales receipt), name, return address and phone number inside of the package.

Cabrio cled4