Pioneer AVH-Z5250BT Owner's Manual page 38

Menu Item Description
[Parking Assist Guide Adjusting the guidelines by dragging or touching
Adjust] / /
Touch [Default] to reset the settings.
• When adjusting the guidelines, be sure to park the vehicle in a
safe place and apply the handbrake.
• Before getting out of the car to place the markings, be sure to
turn the ignition switch off (ACC OFF).
• The range projected by the rear view camera is limited. Also, the
vehicle width and distance guidelines displayed on the rear view
camera image may differ from the actual vehicle width and
distance. (The guidelines are straight lines.)
• The image quality may deteriorate depending on the usage
environment, such as at night or in dark surroundings.
NOTES
• This setting is available only when you stop your vehicle in a safe
place and apply the handbrake.
• Using packing tape or similar tape place markings as shown
below before setting up the guidelines so that the guidelines can
be overlaid to the markings.
[Demo Mode]
Menu Item Description
[Demo Mode] Setting the demo mode.
[On] [Off]
38
En
/ on the screen.
CAUTION
2 m
50 cm
Markings
Markings
Rear bumper
[System Language]
/ /
Menu Item
[System Language]
[Location Setting]
Z5250BT
Menu Item
[Location Setting]
[South America]
[Australia]
[Steering Wheel Control]
Menu Item
[Steering Wheel Control]
[With Adapter] [W/o
Adapter]
25 cm
25 cm
Description
Select the system language.
NOTES
• If the embedded language and the selected language setting are
not the same, the text information may not display properly.
• Some characters may not be displayed properly.
Description
Select the using location.
Description
Select [With Adapter] or [W/o Adapter] according to your
wired remote control.
NOTES
• This setting is available only when you stop your vehicle in a safe
place and apply the handbrake.
• Depending on your vehicle, this function may not work properly.
In this case, contact your dealer or an authorised PIONEER
Service Station.
• Please use a PIONEER wiring harness for each car model when
[With Adapter] mode is engaged, otherwise select [W/o
Adapter].