Tiger Tool 10217 Instructions

Bearing Cup Installer
10217
Safety Warning
Read all instructions and safety warnings prior to operation. Failure to do so could result in
equipment damage, personal injury or even death.
CAUTION: BEFORE ASSEMBLING BEARING CUPS ON ANY "SPICER LIFE SERIES" DRIVELINE, CLEAN OUTSIDE
MACHINED SURFACES OF YOKE TO BARE METAL—DO NOT GRIND!
Stay Alert! Watch what you are doing and use common sense when
•
operating this tool.
Inspect product for damage prior to using; do not use if product is
•
in unsafe condition.
Do not operate tool while under the influence of drugs, alcohol
•
or medication.
Always use safety equipment to prevent injuries. Approved face and
•
eye protection must always be worn by the operator, as well as others
in the work area.

Operating Instructions

1 If necessary, select the SPL 170 or SPL 140 reducer for your
application and insert into bottom of the SPL 250 Adapter.
2 Position u-joint cross and bearing cup onto the yoke. Ensure
grease fitting is in the correct position.
3
Reverse the Forcing Screw so the tool can be positioned
over the yoke/bearing cup.
4
By hand, tighten the Forcing Screw until the bottom of the
frame of the tool is contacting the yoke making sure the
adapter is centered over the bearing cup.
5 By ratchet or impact wrench, apply force to the forcing
screw to press the bearing cup into the yoke. Make sure
the u-joint cross keeps the needle bearings of the bearing
cup in place.
View demonstration videos and a
complete product list at tigertool.com
Do not overreach. Keep proper footing and balance at all times.
•
Dress properly. Do not wear loose clothing or jewelry.
•
Keep your hair, clothing and gloves away from moving parts.
Keep your work area clean and well lit.
•
6
Once the adapter/reducer is pressed flush against the yoke,
reverse the forcing screw to remove the tool.
7 Rotate driveline 180 degrees.
8 By hand, insert the opposing bearing cup into the yoke.
9
Repeat steps 3 to 6 on remaining bearing cups.
Here at Tiger Tool, your satisfaction is our number one
priority. Should you have any questions about this or
any of our products, please call us at 1.800.661.4661.
Have What It Takes
Technical Support
1.800.661.4661