Advertisement
NOTE:
1.
READ THIS DOCUMENT PRIOR TO INSTALLATION. IMPROPER INSTALLATION WILL VOID WARRANTY.
2.
PRODUCT ONLY TO BE INSTALLED & SERVICED BY A SUITABLY QUALIFIED PROFESSIONAL.
3.
NICHE COMPONENTS OF THIS PRODUCT ARE MANUFACTURED FROM ABS. SOME PVC JOINTING
COMPOUNDS ARE NOT COMPATIBLE WITH ABS POSSIBLY RESULTING IN PRODUCT FAILURE.
CHECK JOINTING COMPOUND COMPATIBILITY BEFORE USE.
4.
INSTALLER TO ENSURE INSTALLATION MEETS ALL APPLICABLE ENGINEERING & REGULATORY
REQUIREMENTS.
5.
HYDROSTATIC VALVE IS A REPLACEABLE COMPONENT AND MUST NOT BE GLUED INTO NICHE.
6.
THIS MANUAL CONTAINS IMPORTANT INFORMATION. ONCE INSTALLATION IS COMPLETE
INSTALLER MUST PROVIDE THIS MANUAL TO OWNER/OPERATOR TO STORE IN A SAFE PLACE.
M A I N D R A I N
INSTALL ATION INSTRUCTIONS
(PART NO. 474-202)
Advertisement
Table of Contents
Related Manuals for AQUEA MAIN DRAIN
Summary of Contents for AQUEA MAIN DRAIN
- Page 1 M A I N D R A I N INSTALL ATION INSTRUCTIONS (PART NO. 474-202) NOTE: READ THIS DOCUMENT PRIOR TO INSTALLATION. IMPROPER INSTALLATION WILL VOID WARRANTY. PRODUCT ONLY TO BE INSTALLED & SERVICED BY A SUITABLY QUALIFIED PROFESSIONAL. NICHE COMPONENTS OF THIS PRODUCT ARE MANUFACTURED FROM ABS. SOME PVC JOINTING COMPOUNDS ARE NOT COMPATIBLE WITH ABS POSSIBLY RESULTING IN PRODUCT FAILURE.
- Page 2 Ref: 474-808-09 Registered Design. Specifications subject to change without notice. AQUEA™ is a trademark of Vantage Products Pty. Ltd. The contents of this manual are the exclusive copyright of AQUEA™ and may not be reproduced without written © permission. 2019 Whilst every care was taken in preparation of this document, AQUEA™...
-
Page 3: Typical Installation
PARTS SUMMARY TYPICAL INSTALLATION... -
Page 4: Installation Instructions
INSTALLATION INSTRUCTIONS To assemble Stem into Niche: • Remove contents from Niche. • In a well ventilated area, apply a small amount of ABS-compatible solvent cement to Niche socket & top of Stem as shown (A). ENSURE THREAD IN NICHE REMAINS FREE OF CEMENT. •... - Page 5 Applying pool finish to lid: REMOVE LID FROM NICHE BEFORE APPLYING FINISH. • Ensure Render Plug is inserted into central opening in Lid (A). • Apply pool finish to Lid recess ensuring finished surface is flat & level with outer rim (B). •...
-
Page 6: General Maintenance
12 months by a qualified pool professional. Replace if necessary. FEEDBACK & SUGGESTIONS We are continually looking for ways to improve and expand our product range. Please contact us at hello@aquea.com.au if you have any feedback or suggestions! -
Page 7: Warranty Policy
Refurbished parts may be used to repair the Products. (j) the Product has been subject to abnormal corrosive conditions All repairs are to be carried out by AQUEA or its authorised repairer or abrasive chemicals; only. This warranty do es not cover any costs related to travel, (k) the defect is the result of corrosion or normal wear and tear;... - Page 8 A Q U E A™ (a division of Vantage Products Pty. Ltd.) 1 7 D I A N A D R I V E , B L A C K B U R N N O R T H , V I C T O R I A 3 1 3 0 . W A R R A N T Y S U P P O R T - W A R R A N T Y @ A Q U E A .
Need help?
Do you have a question about the MAIN DRAIN and is the answer not in the manual?
Questions and answers