Singer 1030 Instruction page 35

SEWING A CHAINSTITCH SEAM
Stitch: Straight i
Stitch Width:
Needle Position: As.
stitch Length: 10 to 12only
Take-up Lever: Thread Eyelet
Bobbin-case Insert
Straight-stitch Plate
Zig-Zag Foot * •
1. Draw thread under foot to back of machine,
hold thread end and position needle in
fabric. Lower foot.
• Start machine and stitch to end of seam,
ending with needle in fabric. Do not at
tempt to stitch in reverse or sew off the
fabric edge.
Instrukcje obsługi maszyn do szycia firm Polskich jak i zagranicznych np. Singer Toyota Pfaff Gritzner Łucznik Arka
• Raise presser foot and turn hand wheel to
raise take-up lever to its highest point.
2. Pass scissors under presser foot and draw
out a loop of thread.
3. Hold loop and cut thread about an inch
from end of stitching.
4. Remove fabric from machine by pulling it
straight back, away from you. The thread
end will pull through fabric to the underside
and form a temporary lock.
• Instructions for releasing the chain from
the machine without forming a temporary
lock in the fabric are given on the follow
ing page.
maszynykrawieckie.shophurt.pl
31