TechniSat DIGIT MF4-S Operating Manual page 13

Once the installation assistant has been completed,
the sorting of programmes in the Favourites list will be
made in accordance with your selection.
> To accept the selection, confirm by pressing OK.
Country selection
> Use the arrow keys up/down to select the time
zone corresponding to your country of residence. (Fig.
5-4)
The time will be set automatically depending on your
selection.
> Confirm by pressing OK, to accept your selection,
and proceed to the antenna configuration.
Antenna configuration
In this installation step you can adjust the setting of your digi-
tal receiver to the configuration of your antenna.
> If you wish to accept the standard antenna setting,
use the arrow keys up/down to mark the field
Standard and confirm by pressing OK. (Fig. 5-5)
In this case continue with the item "Updating
Software".
> If the configuration of your receiving installation does
not correspond with the standard setting, mark the
field Manual and confirm by pressing OK.
DiSEqC
> If you have DiSEqC components in your receiving
istallation, mark the field Activate and confirm by
pressing OK
(Fig. 5-6). (Additional information on DiSEqC can be
found in Chapter 10, Technical Terms).
Position A/Option A
> Use the arrow keys up/down to mark the satellite
you wish to receive at the DiSEqC setting Position
A/Option A and confirm by pressing OK. (Fig. 5-7)
Position B/Option A
> Use the arrow keys up/down to mark the satellite
you wish to receive at the DiSEqC setting Position
B/Option A and confirm by pressing OK. (Fig. 5-8)
13
(Fig. 5-3)
(Fig. 5-4)
(Fig. 5-5)
(Fig. 5-6)
(Fig. 5-7)