Getting Started
Unpacking Your System
You should have:
• One main unit (with 2 speakers);
• One remote control;
• One user's guide;
• One Thomson Warranty Card
Installation
To ensure sufficient ventilation, keep the spacing
shown as below:
Front View
MULTI FUNCTION LCD DISPLAY
DIGITAL PLL SYNTHESIZED TUNER
ON•ECO
IR SENSOR
TIMER
10cm
DIGIT AL LOGIC DECK
PLAYBACK/ RECORD
Side View
5cm
CS84 EN new
10cm
CD
TUNING
10cm
OPEN/
CLOSE
10cm
5
Connecting the Speakers
When connecting the speakers, match the red
wires to the red jacks and the black wires to the
black jacks. Each speaker has a black and a red
jack, one for positive and one for negative. The
top two jacks are for the left speaker, while the
bottom two jacks are for the right speaker.
R
Speaker Wire Connection
Push Speaker terminal tab
Release tab to lock wire in
down to insert wire.
the terminal.
NOTE: Make sure the insulation is completely removed from the
ends of the speaker wires at all connection points.
Using the Antenna
Before you use your audio system, you'll want to
make sure the FM antenna is positioned properly.
The FM antenna is the coiled wire connected to
the back of the unit. Uncoil it, making sure it is
fully extended (you may even want to tape it to
the wall behind the unit, if possible. The higher,
the better.)
For better AM reception, move or rotate the unit.
1/9/04, 2:13 PM
EN
L
2